Ametek RO-2127 Reverse Osmosis System

We distribute compatible filters for the Ametek Kleen-Plus RO-2127 Reverse Osmosis System.

Stage 1: P5-10-WF
Stage 2: CC-10
Stage 3: ROM-16C

See the Replacements tab above for more information on each stage and the compatible filters for each stage.

These filters can be purchased below.

• Manufacturer: Ametek RO-2127

• Ametek RO-2127 Reverse Osmosis System Stages:
• Stage 1: The P5-10-WF 5 Micron Sediment Filter Set: Removes dirt, sediment, sand, and other physical particles. Replace every 2 months depending on water quality.
  
  
• Stage 2: The CC-10 Drinking Water Filter: Reduces chlorine taste and odor that may be in your water supply. Replace every 2 months depending on water quality.
  
  
• Stage 3: The ROM-16C RO Membrane: Reduces chemicals, such as chlorine taste and odor, that may be in your water supply. RO Membrane life up to 2 years depending on water quality.

• Ametek RO-2127 Reverse Osmosis System Parts & Accessories:
• Order the OR-38 replacement o-rings for the reverse osmosis housing sumps. The o-rings should be replaced every couple of filter changes.
• Order the o-ring lubricant to help lubricate the o-rings at each filter change.
• Order the SW-1 wrench to help remove the housing sumps when replacing the filters. Do not use the wrench to tighten the sumps. The sumps should be hand tightened.
• When needed, order this RO Tank to replace your existing RO Tank.
• When needed, order this RO Membrane Housing to replace your existing RO Membrane Housing. The reverse osmosis membrane goes inside the RO Membrane Housing. The RO Membrane Housing does not need to be replaced every time you replace the reverse osmosis membrane. Be sure to order the correct fittings on the RO Membrane Housing page to connect the RO Membrane Housing to your reverse osmosis system.

• Ametek KleenPlus RO-2127 Water Filter Change Intervals:
• The filter change interval will vary due to your water quality and the amount of water used.