- Aqua Pure AP815-2 Water Filter Information:
- The Aqua-Pure by Cuno AP815-2 water filter replacement cartridge reduces dirt and rust up to 5 microns. This Aqua-Pure large diameter dual action dirt and rust cartridge is for larger homes and commercial applications. The AquaPure AP815-2 dirt & rust water filter cartridge is made from an exclusive process using pure white celluose fibers. As water passes from the outer surfaces into the center of the cartridge, the filtering pores become increasingly smaller to remove even microscopic particles. Unlike string-wound and pleated paper cartridges, the rigid, sturdy construction of the Aqua-Pure cartridges are able to withstand high pressure drop and stressful conditions such as water hammer.
The AquaPure AP815-2 has been discontinued. You can replace the filter with the
Pentek NCP-20BB filter or the
AquaPure AP817-2 filter listed below.
- CUNO Aqua-Pure AP-815-2 Water Filter Specs:
- Dimensions: 19 7/8” L x 4 5/8” W
- 5 Micron Nominal Filtration
- Flow Rate: 45 gpm / 170.3 lpm
- Dirt and Rust Reduction
- Graded Density for Long Life (up to 30% longer!)
- Rigid Construction Withstands Stressful Conditions
- Use on Hot & Cold Water (up to 100° F)
- Made from FDA (CFR 21) Compliant Materials
- Dual Action
- Normal Sediment Removal
- Bad Taste/Odor Reduction
- Manufacturer: Aqua-Pure AP815-2
- Housings for the CUNO AquaPure AP815-2 Water Filter:
- AquaPure AP802 Whole House System
- AquaPure AP802-1.5 Whole House System
- AquaPure AP802-1.5-C Whole House System
- CUNO Aqua-Pure AP815-2 Replacement Water Filter Instructions:
- The AquaPure AP815-2 water filter needs to be replaced every 3-4 months. The filter may need to be replaced sooner depending on your water quality and your water usage.
- Instructions on how to change the CUNO Aqua-Pure AP815-2 Replacement Water Filter Cartridge:
- Turn off incoming water
- Bleed pressure from the unit by depressing the red button on top of unit
- Remove housing by sliding wrench up toward head then turn left to unscrew
- Wipe housing clean and insert new cartridge
- Lubricate o-ring and screw housing into head
- Turn water back on