AS-301E Arsenic Reduction Water Filtration System:
The AS-301E Water Filtration System reduces both Arsenic III and Arsenic V
Reduces chlorine taste and odor
Reduces down to 10 microns of sediment
1000 gallon metered claimed capacity based on NSF test protocol
The AS-301E Arsenic Treatment System comes complete with filters, installation kit, faucet, and tubing
The second stage of this arsenic water filter puts in iron and the third stage (EPM-10) takes out the iron.
Arsenic Water Filtration System AS-301E Specs:
3 Stage Arsenic Reduction System
Pressure Range: 2.1 – 8.62 bar (30 – 125 psi)
Temperature Range: 4.4 – 37.8°C (40 – 100°F)
Service Flow Rate @60 psi (4.1 bar): 2.3 Lpm at 4.1 bar 0.6 gpm
Rated Service Life: 3,785 L (1000 gallons)
Dimensions: 394 mm x 133 mm x 356 mm (15.5 in. x 5.25 in. x 14 in.)
Weight (filled with water): 19 lbs.
AS-301E System Recommended Accessory:
Use the SW-1 housing wrench to remove the housing sumps. The wrench should NOT be used to tighten the housing sumps back onto the housing caps. Tightening may cause damage to the o-ring. The wrench is not included with the original system purchase.
AS-301E Arsenic Reduction Replacement Water Filters:
The AS-CK water filters are the replacement filter cartridge kit for the Arsenic Reduction System AS-301E. One AS-CK water filter set is included with the system purchase.
The Pentek EPM-10 Carbon Block Water Filter cartridge is the 3rd filter used in the system. The EPM-10 can be purchased here. One EPM-10 water filter set is included with the system purchase.
Filter cartridge life is approximately 1000 gallons or 1 year. The filter cartridge life also depends on the quality of your water and the amount of water used.
AS-301E System Replacements Parts:
151121 OR-233 Replacement O-Rings. The O-Ring seals the cap to the sump and should be replaced periodically to prevent leaks. The system comes with all the OR-233 o-rings needed for initial installation.
Pentek AS-301E Arsenic Filtration System Installation Instructions:
The Arsenic AS-301E System should be installed on a 3/8" cold water line.
Parts Included: Filter System with Filter Cartridges
Lead-Free Faucet
Installation Hardware (mounting screws, saddle valve, fittings)
6.35 mm (1/4-inch) Tubing
Help Me Order!
Contact Us M-F 9-5 CST
(612) 605-6910
(888) 801-PURE