- CUNO Water Factory 45-601 Filter Housing Wrench Information:
- Use the 45-601 wrench to loosen bottom of housing during cartridge replacement. Slide circular end over housing until a snug fit is achieved and unscrew.
- Do not use the CUNO 45-601 wrench to tighten the bottom of the housing. Only hand-tighten the bottom of the housing onto the cap to prevent cracking.
- The CUNO Water Factory 45-601 makes changing water filters easy.
- The CUNO 45601 wrench is approximately 4.25 Inches Wide. (Note: Width is slightly less at the notches.)
Replace the CUNO Water Factory 45-601 Wrench with the
SW-1 Wrench below.
- Manufacturer: CUNO Water Factory 45-601
- Use the CUNO Water Factory 45-601 Wrench With:
- #5 & #10 Slim Line Housings
- 3/8" Inlet/Outlet Slim Line Housings
Larger View
Features
