The Culligan RVF-10 recreational vehicle water filter is a complete and compact system designed to fit in your recreational vehicle or boat.
The Culligan RVF-10 system is designed to reduce foul tastes, odors and sediment from potable drinking water. This system includes 3/4" flexible hose couplings, one foot flexible hose, and the D-15 replacement cartridge.
The Culligan RVF-10 RV filter system comes complete with the D-15 water filter cartridge. The D-15 filter removes contaminants from your drinking and cooking water.
The Culligan RVF-10 RV Water Filter System with the D-15 filter reduces chlorine taste and odor, bad taste and odor, and sediment.
The Culligan RVF-10 RV Water Filter System produces healthier, better-tasting drinking and cooking water on the road in your RV.
The Culligan RVF-10 RV Water Filter System features simple installation.
The Culligan RVF-10 is a 3/8" housing.
Contaminant Removal:
Chlorine
Bad Taste and Odor
Sediment
Culligan RVF-10 Recreational Vehicle Water Filter System Specs:
Complete unit is ready to hook up to your RV or boat
Housing is made of a durable plastic
Housing is 11.5" in height x 4.5" in diameter
Twelve inch flexible connector hose hooks up quickly to your RV
3 gallons-per-minute maximum flow rate
One NCP-10 pleated carbon non-cellulose filter cartridge included
NCP-10 filter cartridge is 9.75" in height and 2.75" in diameter
One D-15 replacement water filter cartridge is included with purchase of the Culligan RVF-10 water filter system.
Water filter cartridge life for one D-15 replacement water filter cartridge is up to 250 gallons. The D-15 filter life also depends on the quality of your water.
The OR-38 is the replacement o-ring for the Culligan RVF-10 system. One OR-38 o-ring is included with the Culligan RVF-10 filter system.
NOTE: The RVF-10 system must be protected from freezing. Failure to do so may result in cracking of the filter and water leakage.
Culligan RVF-10 RV Water Filter System Installation Instructions:
1. Wrap the 3/8-inch fitting (on the 3/4-inch female hose adapter) with plumber's tape (included), and screw into the INLET side of the filter system. Wrap the male hose adapter with plumber's tape and screw into the OUTLET side of the filter system. Use a wrench to tighten firmly. DO NOT OVERTIGHTEN. About one thread should remain visible when fittings are tightened.
2. To protect the system from possible damage, install the system between two hoses. The short hose (included) should be used to connect the outlet side of the filter system with the storage tank inlet. A sanitary hose can be used to connect the water faucet to the inlet side of the filter system.
3. Before running water through the RVF-10 system into the storage tank, flush out any carbon fines that may be present in the carbon cartridge. Disconnect the hose at the storage tank and turn the water supply on for approximately one minute. Turn off water supply and reconnect the hose to the storage tank.
Larger View
Features
