Everpure Polaria Instant Water Chiller CGCL-1 Features:
The Everpure Water Chiller is a Commercial Grade Water Chiller that installs discreetly under almost any sink for ultimate convenience.
The CGCL-1 is a compact, highly efficient water chiller designed for use with any drinking water faucet and installs directly under the kitchen counter, in a well-ventilated cabinet.
This Water Chiller is manufactured with a waterway system utilizing stainless steel components and completely lead-free materials which COMPLIES WITH THE LEAD-FREE
DEFINITION IN THE SAFE DRINKING WATER ACT OF 1986
AND LEAD CONTAMINATION CONTROL ACT OF 1988.
The CGCL-1 Commercial Grade Water Chiller features a whisper-quiet, hermetically sealed, maintenance-free compressor, which uses an ozone-friendly HFC-134 refrigerant.
Everpure Polaria Instant Water Chiller CGCL-1 Specs:
Capacity: 1.3 gallons per hour of 50°F drinking water, based upon 80°F inlet water and 90°F ambient. (A.R.I. Standard Ratings)
Tank Volume: 0.7 gallons
Tank: Stainless Steel
Measurements: 14" high by 7" wide and 17" deep
Inlet/Outlet: 1/4” O.D. tubes
Power: 155 watts; 1.7 amps
Motor Compressor: Hermetically sealed, reciprocating type, 1/18 HP, 115VAC, 60Hz single phase. Sealed in lifetime oil supply
Condenser: Fan cooled, copper tube with aluminum fins. Fan motor is permanently lubricated
Cabinet: Rust-resistant, galvanized steel
Drain Plug: Plastic with an o-ring seal, designed for potable water applications
Rating: Approved by Underwriters Laboratories Inc. in accordance with NSF/ANSI 61-2002e
Everpure Polaria Instant Water Chiller CGCL-1:
The Everpure CGCL-1 does not come with a filter, therefore it should be combined with an Everpure water filtration system to filter the water.
Everpure Polaria Instant Water Chiller CGCL-1 Instructions:
This unit is intended to be installed underneath a conventional kitchen sink, in a cabinet not less than 36" (914mm) wide (inside dimension).
Use with an Everpure Commercial Grade Water Filtration System.
Connecting lines to be of copper, thoroughly flushed to remove all foreign matter before being connected to cooler.
Connect cooler to supply line with a shut-off valve and install a 1/4" O.D. (6 mm) tube. Make sure the cold water connecting to the faucet is filtered.
Help Me Order!
Contact Us M-F 9-5 CST
(612) 605-6910
(888) 801-PURE