The Pentek 150576 3G housing has 3/4" inlet/outlets.
The Pentek 150576 filter housing also features a mounting bracket built-in to the cap for easy installation.
The red pressure-relief button on the cap makes filter changes easier by releasing any pressure inside the housing.
The Pentek 150576 housing must be used with one of the two Pentek pressure gauges. The housing will not work if a pressure gauge is not used. The pressure gauge helps to determine when the water filters need to be replaced.
The Pentek 3G IB MM 150576 water filter housing has an integrated bracket so a separate bracket does not need to be purchased.
Connecting two #20 Standard 3G Housings:
Two #20 Standard 3G housings can be connected with a pipe nipple or pipe union. There are several pipe nipples available that can be used to connect two #20 Standard 3G Housings. See all combinations of pipe nipple options here.
NP-34 - Use this pipe nipple to connect two #20 3G Housings with 3/4" Inlet/Outlets
Pentek 150576 #20 Filter Housing Specs:
Dimensions: 23.5" x 5.75" (597 mm x 146 mm)*
*Height does not include required meter. Add 1.75" for the 143549 meter.
Housing: Polypropylene (Opaque)
Cap: Reinforced Polypropylene
O-Ring: Buna-N
Manufacturer: Pentek 150576
Most Popular Water Filters for the Pentek 150576 #20 Filter Housing:
Will accommodate a wide range of 2-1/4" to 3-1/8" diameter cartridges.
Replacement OR-34 O-Rings. One o-ring is included with the housing purchase, but you should replace the o-ring periodically to prevent leaks.
Use silicone grease to lubricate the o-rings to prevent leaking.
Use the SW-2 housing wrench to remove the sump. The wrench should NOT be used to tighten the sump back onto the cap. Over tightening may cause damage to the o-ring.
Easy to install #20 Blue Water Filter System. The housing is 23.5" L x 5.75" W (597 mm x 146 mm). You will need to allow slightly more room in addition to the housing dimensions for installation and for the required 143549 meter. The meter is 1.75" in height.
3/4" inlet/outlet for easy installation on a cold water line.
A mounting bracket is built into the housing for installation of the water filter housing. You do not need to purchase a separate mounting bracket.
NOTE: When installed, protect housing against freezing to prevent cracking of the filter and water leakage.