Nominal 7 Micron Activated Carbon Water Filter for Electroplating Solutions
The Pentek ELPC20 is the best technology available for cartridge filtration for use in a wide range of electroplating applications.
Unique manufacturing technology ensure that there is no bleeding of carbon fines into the plating bath
The carbon used is an ultra-clean, highly purified carbon to ensure that sulfur is not leached into the plating bath.
The Pentek ELPC-20 water filters have superior dirt holding ability due to fibrous physical structure and manufacturing process that results in a product with true depth filtration.
True depth filtration results in maximum treatment with minimum pressure drop through the cartridge.
End cap gaskets are permanently molded onto the end caps to ease in change-out of filter cartridges
NOTE: Micron ratings based on 85% or greater removal of given particle size.
NOTE: Cartridges will contain a very small amount of carbon fines (very fine black powder) and a new cartridge after installation should be flushed with sufficient water to remove all traces of the fines from your water system before using the water. Each time you use your filtered water tap for drinking or cooking purposes it is recommended that you run (flush) the tap for at least 20 seconds prior to using water.
NOTE: Performance capacity depends on system design, flow rate and certain other application conditions. Certain states require system registration or certification for health-related contaminant reduction claims.
NOTE: Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system.
Pentek / Fibredyne ELPC-20 Water Filter Cartridge Specs: