Nominal 10 micron Modified Epsilon Carbon-Briquette Water Filter Cartridges
Highest carbon block dirt holding capacity for maximum cartridge life (based on manufacturer's internal testing)
Bad taste & odor and chlorine taste & odor reduction (based on manufacturer's internal testing)
Low pressure drop
Pentek EPM-20 cartridges are a modified version of the “EP Series” cartridge. An economical price makes this cartridge suitable for taste, odor and chlorine taste &
odor reduction, as well as sediment filtration. When greater chlorine taste & odor reduction is needed, use the EP-20 water filter
Ametek EPM-20 cartridges are manufactured using a patented process that yields a cartridge with a nominal 10-micron filtration rating, high porosity and chlorine
taste & odor reduction. The high porosity design helps prevent the cartridge from plugging before its adsorption capability is exhausted, maximizing the
utilization of the carbon while maintaining low pressure drop.
These EPM Series cartridges are protected by Endurawrap™, a uniquely formulated polyolefin bilaminate pre-filter, designed to significantly increase the useful life of
the cartridge by trapping sediment that typically plugs carbon block cartridges.
Pentek EPM-20 cartridges are manufactured entirely from FDA-compliant materials making them an ideal choice for a wide range of residential, food service,
commercial and industrial applications.
NOTE: Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system.
NOTE: Cartridges will contain a very small amount of carbon fines (very fine black powder) and a new cartridge after installation should be flushed with
sufficient water to remove all traces of the fines from your water system before using the water. Each time you use your filtered water tap for drinking or
cooking purposes it is recommended that you run (flush) the tap for at least 20 seconds prior to using water.
NOTE: Performance capacity depends on system design, flow rate and certain other application conditions.
NOTE: When greater chlorine taste & odor reduction is needed, use the EP series water filters.
Pentek EPM-20 Carbon Water Filter Cartridge Specs:
Dimensions: 20" x 2-7/8" (508mm x 73mm)
Micron Rating (Nominal): 10 Micron
Temperature Rating: 40°F to 180°F (4.4° C to 82.2°C)