Water Filters Home > Whole House Water Filters > PCF1-10MB Deionization Water Filter

Pentek / Ametek / Culligan /
Kleen Plus / Plymouth Products /
Pentair / American Plumber /
US Filter PCF1-10MB
Deionization Water Filter

• Pentek / Ametek PCF1-10MB Deionization Water Filter Cartridge:
• FDA D.I. Resin Mixed Bed Deionization Water Filter Cartridges
• Pentek PCF1-10MB filters are designed for deionizing water up to 16 megohms
• Manufactured using an FDA-compliant resin that has been subjected to additional postproduction steps to minimize the total organic carbon (TOC) level.
• High-capacity, semi-conductor-grade resin cartridges are ideal for use in pharmaceutical and medical laboratories, cosmetics, and circuit board printing applications.
• Convenient and cost effective for many applications where low levels of total organic carbon (TOC) and total dissolved solids (TDS) are required.
• PCF Series cartridges have been developed in response to the requirements for deionized water in many industries.
• NOTE: For drinking water use, do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system.
• CAUTION: Do not use cartridges on equipment that has an electric conductivity water level indicator.

• Commercial and Industrial Applications for Deionization Water Filters:
• Circuit board printing
• Pharmaceutical use
• Steam and humidification
• Cosmetics
• Steam processors
• Humidification systems
• Recirculating/cooling towers
• Power generating equipment
• Medical/laboratory use
• Lasers
• Jet water sprayers
• Boiler make-up water

• Pentek PCF1-10MB Deionization Filter Cartridge Specs:
• Dimensions: 9-3/4" x 2-2/3" (248 mm x 68 mm)
• Capacity Grains (mg TDS as CaCO3): 270 (17,500)
• Initial ΔP (psi) @ Flow Rate (gpm):
  1.5 psi @ 0.25 gpm (0.10 bar @ .95 L/min)
• Suggested Flow Rate:
  0.25 gpm (0.95 L/min)
• Temperature Rating:
  40°F to 100°F (4.4°C to 37.8°C)

• Pentek PCF1-10MB Deionization Water Filter Materials of Construction:
• Filter Media: Mixed bed DI resins
• End Caps, Shell, Pre-Filter, and Post-Filter: Polypropylene
• Gasket: Buna-N

• Water Filter Housings for the Pentek Deionization PCF1-10MB filter:
• 155273 PCF1-10MB FDA D.I. Resin filter fits in standard and Slim Line housings for 10 inch Standard water filters.
• Fits in Culligan / USFilter / Ametek / Pentek 10" Standard Water Filter System