- RO-1070-W14 Bladder Tanks for Reverse Osmosis Systems:
- 14 Gallon Reverse Osmosis System Accumulator Tank for Reverse Osmosis Systems
- There is a side mounted air valve for re-pressurizing the tank when needed.
- The RO Tank has a 1/4" NPT stainless steel connector at the top of the tank.
- This RO Tank can replace an existing Reverse Osmosis Water Storage Tank or increase your water storage capacity by Teeing off your existing line. If you tee off for an additional RO Storage Tank, make sure that both tanks have the same pre-charge.
- This RO tank has been tested and certified by NSF International under NSF/ANSI Standard 58 for material and structural integrity.
- A tank stand is included with the purchase of this tank.
- Note: The actual water storage capacity of RO tanks is not the stated size. Reverse Osmosis water storage tanks have an internal bladder and an air pocket. The actual water storage capacity will depend on the air pressure inside the tank, the water pressure and the shut off pressure.
- Reverse Osmosis Tank Specs:
- Maximum Working Pressure: 100 psi
- RO Tank is pre-charged
- 1/4" NPT stainless steel connector at top
- Side mounted air valve
- Tank stand included
- NSF 58 listed
- 15" Diameter x 23" Height
- Manufacturer: Tier1 RO-1070-W14
- Reverse Osmosis System Accessories:
- Use a TPG-100 Digital Tank Pressure Gauge to measure the air pressure in your Reverse Osmosis Bladder Tank. The RO Bladder Tank can lose air pressure and needs to be monitored.
- Use an Inline TDS Meter to monitor the Total Dissolved Solid levels before and after your Reverse Osmosis System.
- Use the BV-3890-AP Ball Valve when installing an RO tank into 3/8" water line.
- Use the BV-1490-AP Ball Valve when installing an RO tank into 1/4" water line.
- Instructions to Properly Pressurize your Reverse Osmosis Tank:
- Before setting the pressure on your tank, you should empty the tank of water.
- There are two nipples on the tank. The nipple on the bottom should have a blue cap on it. Remove this cap and use a bicycle pump to add pressure to the tank.
- You should use a digital pressure gauge on the nipple because non-digital pressure gauges are not sensitive enough. You can purchase a digital pressure gauge here if you do not already have one
- Correct pressure for your Tank:
- The recommended pressure for your tank depends on the size of your tank. The most common tank size is 3.2 gallons. For these and similarly-sized tanks, you should have pressure of 8 psi when the tank is empty. If the tank is full, there should be 36 psi.
- For larger tanks, such as 14 gallon, 36 gallon, 44 gallon, and 86 gallon units, the pressure will need to be greater.