Samsung DA29-00003G Refrigerator Water Filter

The Samsung Aqua-Pure Plus Refrigerator Water Filter fits Samsung refrigerators with a short round filter, and replaces the "B" model which was recently discontinued. The filter uses Activated Carbon Block to remove contaminants for up to 6 months.

• The DA29-00003G is Samsung's newest design - a slight improvement over the older DA29-00003B

Contaminant Removal:

• 97.60% of Chlorine
• 98.40% of Particulates (Class I)
• 99.30% of Lead at pH 6.5
• 99.40% of Lead at pH 8.5
• 96.60% of Mercury at pH 6.5
• 88.90% of Mercury at pH 8.5
• 99.00% of Asbestos
• 96.40% of Benzene
• 99.80% of P-Dichlorobenzene
• 99.99% of Cysts
• 98.70% of Carbofuran
• 98.60% of Turbidity

Filter Type: Activated Carbon Block

Filter Life: 6 months or 300 gallons

Flow Rate: 0.5 gallons per minute

Size: 5 1/2 inches (length) x 3 1/4 inches (diameter)

UPC: 036725529038

Country of Origin: Mexico

The DA29-00003G is also known by the following part numbers:

• DA29-00003G, WF289, DA29-00002, DA29-000028, DA29-00002A, DA29-00002A-8, DA29-00002A-B, DA29-00003, DA29-000038, DA29-00003H, DA29-0002, DA29-00028, DA29-0002B, DA29-0003, DA29-0003G, DA2900002, DA29000028, DA2900002A, DA2900002B, DA2900003, DA2900003A, DA2900003G, DA2900003H, DA290002, DA2900028, DA290002B, DA290003, DA290003G, DA61-00159, DA61-00159A, DA61-00159A-8, DA61-00159A-B, DA61-159, DA61159, DA97-06317A, HAFCU1, HAFCU1/XAA, HAFCUI, HAFIN2, HAFIN2/EXP, PS2509506, TADA29-00003A, W10132126, WF-289

Installation Instructions:

1. Twist the old filter a quarter-turn counterclockwise
2. Pull the filter straight down and discard (don't worry, the water will shut off automatically)
3. Push the new filter up into the fridge until it stops
4. Twist the filter a quarter-turn clockwise
5. Reset your 'change filter' light (if your fridge has one)
6. Note: If you have a hard time installing your new filter, close the water supply valve (usually behind the fridge) and then dispense a small amount of water - this should relieve the pressure and allow the new filter to screw right in

Resetting your 'change filter' indicator:

1. Press and hold the ice type and child lock buttons (at the same time) for 3 seconds - the light should turn green
2. Note: If you hold these buttons for 5 seconds, you'll cancel the reset process, and you'll have to do it again. If this happens, just release the buttons and start over.