select Compare (0)
Compare Products

You have no items to compare.

Pentek ECP1-10 Pleated Sediment Water Filters (9-3/4-inch x 2-5/8-inch)

More Views

Pentek ECP1-10 Pleated Sediment Water Filters (9-3/4-inch x 2-5/8-inch)

0 0
$8.99 (Retail Price: $12.35 )

In stockShips Today, Dec 01st

    • Quantity
    • Unit Price
    • 6 +
    • $8.69
Pentek ECP1-10 water filter cartridges have a special formulation of resin-impregnated cellulose and polyester fibers. The Pentek ECP1-10 water filters provide higher wet strength than regular cellulose cartridges. The Pentek ECP1-10 water filters also provide high flow rates and dirt-holding capacity, while maintaining extremely low pressure drop. The Pentek ECP1-10 replacement filter cartridge has minimal unloading and media migration. The Pentek ECP1-10 water filter media is pleated around a polypropylene core for added strength and the ends are immersed in a thermosetting vinyl plastisol. Embedding and sealing each end of the pleat block in this fashion fuses the components together, forming a unitized end cap and gasket. The Pentek ECP water filter cartridges contain more media surface area than most competitive cartridges. The standard 10-inch ECP cartridges contain six square feet of media, where most cartridges contain only 4.5 square feet. The Pentek ECP1-10 replacement filter cartridge is not recommended for non-chlorinated water supplies. Cellulose may start to break down if there is bacteria present in well water or other non-chlorinated water supplies. NOTE: Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. The Pentek ECP Series cartridges have end caps that are color-coded for micron rating: Tan = 1 micron, White = 5 micron, Blue = 20 micron and Yellow = 50 micron. Nominal 1 micron Pentek ECP1-10 Pleated Cellulose Polyester Water Filter Cartridge.
  • Genuine OEM Product
Reduces the following contaminants:
  • Dirt
  • Fine Sand
  • The PENTEK-ECP1-10 does not reduce fluoride
  • Hard Scale
  • Rust and Corrosion
  • Sand
  • Sediment
Used In Brands Ametek, Culligan, Pentek, US Filter
Manufacturer's Id ECP1-10
UPC 051678481431
Advertised Size (in) 10 x 2-1/2
Actual Size (in) 9 3/4 inches (length) x 2 5/8 inches (outside diameter)
Actual Size (cm) 24.77 x 6.67
Media Cellulose Polyester
Primary Filter Media Pleated Polyester
Materials of Construction Core: Polypropylene, End Caps: Vinyl Plastisol
Filter Life (months) 6 months
Micron Rating (Nominal) 1
Operating Temperature (°F) 40 - 125
Operating Temperature (°C) 4.4 - 51.7
Flow Rate (gpm) 10
Flow Rate (lpm) 37.854
Additional Information End Cap Color: Tan
  • Water Filter Housings for the Pentek ECP1-10 Water Filters:
  • 255481 Pentek ECP1-10 filter fits in housings for 10 inch water filters.
  • Fits Culligan / USFilter / Ametek / Pentek 10" Standard Whole House Water Filter System
  • Fits Culligan HF-360 Whole House Water Filter System