Genuine Whirlpool 4396710 Advanced Refrigerator Filter (OEM)

The Whirlpool Refrigerator Water Filter fits Whirlpool, KitchenAid, Kenmore, Amana, Maytag, and Jenn-Air side-by-side refrigerators with a push-button filter located in the grille at the bottom of the fridge. The filter uses Activated Carbon Block to remove contaminants for up to 6 months.

Contaminant Removal:

• 97.40% of Chlorine
• 99.70% of Particulates (Class I)
• 99.35% of Lead at pH 6.5
• 99.31% of Lead at pH 8.5
• 96.70% of Mercury at pH 6.5
• 91.20% of Mercury at pH 8.5
• 99.93% of Asbestos
• 96.30% of Benzene
• 99.70% of P-Dichlorobenzene
• 99.99% of Cysts
• 85.60% of Atrazine
• 92.96% of Toxaphene
• 93.06% of 2,4-D
• 99.30% of Turbidity

Filter Type: Activated Carbon Block

Filter Life: 6 months or 200 gallons

Flow Rate: 0.5 gallons per minute

Size: 12 inches (length) x 2 3/4 inches (diameter)

UPC: 050946962115

Country of Origin: Taiwan

The 4396710 is also known by the following part numbers:

• 4396710, 09020, 2260515, 2260538, 4396710B, 4396710T, 4396711B, 46-9020, 46-9020P, 4609020000, 469020, 469020P, 6710, 9020, 9020B, 9020P, AP3710633, FILTER3C, P1KB1, P1KB2, P1RFKB1, P1RFKB2, P1RFWB2, P1RFWG2, P1WB2, P1WB2L, PB-SS, PBSS, PS971185, RWFFRSXS, T1KB1, T1KB2, T1RFKB1, T1RFKB2, T1RFWB2, T1RFWG2, T1WB2, T1WB2L, W10121145, W10177635

Installation Instructions:

1. Press the button to the left of the filter to release it
2. Pull the filter straight out (don't worry, the water will shut off automatically)
3. Remove the reusable color-keyed cap from the end
4. Discard the old filter
5. Twist the cap onto the end of the new filter
6. Push the new filter straight in until it 'clicks' into place
7. Reset your 'change filter' light (if your fridge has one)

Resetting your 'change filter' indicator:

1. Press the light switch (the one that the refrigerator door presses every time you close the door) 5 times within 10 seconds or if the fridge has a filter button, press and hold it for 5-10 seconds