350 ML Inline RO Membrane Flow Restrictor (36 GPD)

Use the 350 Milliliter Flow Restrictor with 36 GPD RO Membranes. The flow restrictor is used to create pressure throughout the reverse osmosis membrane element. The flow restrictor also maintains a desired ratio of reject flow (to drain) and permeate (product) flow. The 350 ML flow restrictor has the direction of flow and flow rate indicated on the restrictor.

Instructions

1. 1. The flow restrictor should be changed every time the reverse osmosis membrane is changed
2. 2. Be sure that you order the flow restrictor ML size to match your reverse osmosis membrane GPD. They must match to operate at the correct efficiency. For the 350 ML flow restrictor, the RO Membrane must be 36 Gallons Per Day
3. 3. These are inline capillary systems that install into the drain tube itself. Just cut the 1/4-inch drain tube and push the two ends of the tube into the flow restrictor
4. 4. If an inline flow restrictor is already installed, remove the old inline flow restrictor and insert the new inline flow restrictor
5. 5. Change your filters and membrane at the recommended frequency
6. 6. Clean your system occasionally with a product like Sani-System SS96RO, an easy to use, pre-measured, reverse osmosis system sanitizer (purchasable separately)