select Compare (0)
Compare Products

You have no items to compare.

Pentek Fibredyne ELPC-10 Water Filter (1 Case / 30 Filters)

More Views

Pentek Fibredyne ELPC-10 Water Filter (1 Case / 30 Filters)


PENTEK-ELPC-10   +$0.00

* Required Fields

The best technology available for cartridge filtration for use in a wide range of electroplating applications. Unique manufacturing technology ensures that there is no bleeding of carbon fines into the plating bath. The carbon used in the Pentek ELPC-10 is an ultra-clean, highly purified carbon to ensure that sulfur is not leached into the plating bath. Superior dirt-holding ability due to fibrous physical structure and manufacturing process that results in a product with true depth filtration. True depth filtration results in maximum treatment with minimum pressure drop through the cartridge. The Pentek ELPC-10 end cap gaskets are permanently molded onto the end caps to ease in change-out of filter cartridges. NOTE: Micron ratings based on 85% or greater removal of given particle size. NOTE: Cartridges will contain a very small amount of carbon fines (very fine black powder) and a new cartridge after installation should be flushed with sufficient water to remove all traces of the fines from your water system before using the water. Each time you use your filtered water tap for drinking or cooking purposes it is recommended that you run (flush) the tap for at least 20 seconds prior to using water. NOTE: Performance capacity depends on system design, flow rate and certain other application conditions. Certain states require system registration or certification for health-related contaminant reduction claims. NOTE: Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. Nominal 7 Micron Activated Carbon Water Filter for Electroplating Solutions.
  • Genuine OEM Product
  • Pentek / Fibredyne ELPC-10 Water Filter Cartridge Specs:
  • Dimensions: 9-3/4" x 2-7/8" (248 mm x 73 mm)
  • Micron Rating (Nominal): 7
  • Initial ΔP (psi) @ Flow Rate (gpm): 3.4 psi @ 1 gpm (0.2 bar @ 3.8 Lpm)
  • Temperature Rating: 40ᄎF to 180ᄎF (4.4ᄎC to 82.2ᄎC)
  • Pentek / Fibredyne ELPC-10 Electroplating Solutions Filter Materials of Construction:
  • Filter Media: Bonded PAC
  • End Caps: Polypropylene
  • Netting: Polyethylene
  • Gasket: Santoprene
  • Water Filter Housings for the Fibredyne ELPC-10 water filter cartridge:
  • 255668 ELPC-10 filter fits in standard and Slim Line housings for 10 inch Standard water filters.
  • Fits the Culligan / USFilter / Ametek / Pentek HF-360 Water Filter System