BevGuard BGC-2100S Water Filter with Polyphosphate Scale Inhibitor

SKU
BEVGUARD-BGC-2100S
Price $58.79
Availability: In stock
Choose a quantity
  • 1 Filter $58.79  
  • 3 Filters Price $56.99 each
  • 6 Filters Price $55.29 each
BevGuard BGC-2100S Water Filter with Polyphosphate Scale Inhibitor & Polypropylene Filtration Cartridge reduces hard water spots from limescale buildup on equipment. The graded density spun bonded polypropylene filtration cartridge helps in removal and reduction of sediment that may be present in your drinking water. This water filter keeps the good minerals intact. This filter should not be used with water that is microbiologically unsafe or of unknown quality, without adequate disinfection before and/or after the filter. BevGuard filters have been tested by the manufacturer against ANSI/NSF Standard 42 for material requirements only. BevGuard BGC2100S offers you protection up to twelve months. Leverage this economical, yet effective, option to get the cleanest water possible.
Package Qty 1
Actual Size (in) 12 1/4 inches (length) x 3 3/16 inches (width)
Actual Size (cm) 31.115 x 8.09625
Filter Life (gallons) 10,000
Filter Life (liters) 37,854.10
Filter Life (months) 12 months
Micron Rating (Nominal) 5
Operating Pressure (psi) 25 - 125
Operating Temperature (°F) 35 - 100
Operating Temperature (°C) 1.7 - 37.8
Flow Rate (gpm) 1.67
Flow Rate (lpm) 6.32

Installation Guide

User Guide

Instructions

  1. Turn off inlet water to the filter system. Turn off equipment receiving water if recommended by the manufacturer Depressurize the system To remove
  2. Turn the filter cartridge counterclockwise until the filter comes loose from the head connector Locate the replacement cartridge and remove from packaging
  3. Insert cartridge end into the head. Insure that the filter is pressed completely into the head and turn clockwise until the filter stops turning. Turn on supply water slowly to the system Check for leaks at filter connection
  4. Carbon fines may be present in the water. After installation flush cartridge for 5 minutes before using the water. Replace filters annually (Note that filters may need to be replaced sooner due to water conditions)
  5. Do not use this device on microbiologically unsafe water or unknown quality without adequate disinfection before or after the system. Do not allow the filter to freeze, which can cause structural damage the housing which may cause a water leak
  6. Make sure that the installation complies with all state and local laws and regulations
  7. The replacement cartridges in this system have a limited service life. Changes in taste, odor, color and flow of the water being filtered indicate that one or all of the cartridges need to be replaced
  8. The contaminants or other substances removed or reduced by these cartridges are not necessarily in the water supply
  9. To understand your water better request a current analysis from your local water municipality or have a private analysis conducted by a reputable water testing lab
  10. After prolonged periods of non-use it is recommended that the system be flushed thoroughly and the system may benefit from a filter change

Reset Instructions