Omnipure Q5621 Carbon Block Water Filters

The Omnipure Q5621 Block GAC filter is very user-friendly. Replacement of the spent media bed is done quickly by detaching the filter body from a permanent head with a twist of the wrist. The new Q5621 filter body is just as easily threaded into the head and the replacement is then complete. The Omnipure Q5621 is also available with the optional Twist Tap in-head valve system, which automatically turns the supply water off when the body is disconnected from the head. The Omnipure Q5621 Water Filter can be used in icemakers, refrigerators, beverage equipment, drinking fountains, undersink systems, and reverse osmosis systems. The Omnipure Q5621 GAC water filter is a 10 micron granular activated carbon block filter used to reduce taste, odor and chlorine taste and odor.

• Made in the U.S.A.
• Genuine OEM Product

Reduces the following contaminants:

• 99.00% of Chlorine Taste & Odor
• The OMNIPURE-Q5621 does not reduce fluoride

Used In Brands	Omnipure
Manufacturer's Id	Q5621
UPC	799932588884
Advertised Size (in)	12 x 2-1/2
Media	Activated Carbon Block
Primary Filter Media	Activated Carbon Block
Filter Life (gallons)	2,500
Filter Life (liters)	9,463.53
Filter Life (months)	12 months
Micron Rating (Nominal)	10
Maximum Operating Pressure (psi)	125
Operating Temperature (°F)	35 - 100
Operating Temperature (°C)	1.7 - 37.8
Flow Rate (gpm)	0.5
Flow Rate (lpm)	1.893
Additional Information	Fitting Size: This Q-Series filter is a replacement filter and must be used with an existing Q-Series head

• Omnipure Q5621 Water Filters are designed to fit:
• Omnipure Twist Tap filter heads QNVH B, C, or J, with or without automatic shutoff.
• If you do not have a head for the Omnipure Q-Series filters, you can purchase one of the Omnipure Q-Series heads below in the Related Products section. These heads are valved which means the water will automatically shut off when replacing the Q-Series water filter. The heads are available with 1/4" quick connect fittings, 1/4" NPT, or 3/8" NPT.

Instructions

1. 1. Omnipure Q5621 water filters should be installed on cold water lines only
2. 2. Omnipure Q5621 water filters should not be used where the water is microbiologically unsafe
3. 3. Each time you change your filter, clean and apply silicone food grade lubricant (such as OR-LUBRICANT-LG or OR-LUBRICANT-SM) generously to both the small and large o-ring in the Q-Series Head
4. 4. It is recommended that you replace the Omnipure H-118 O-Ring every time you change your filter
5. 5. The H-118 O-Ring is the larger of the two o-rings in the Q-Series Head System
6. 6. If you do not replace the H-118 O-Ring, you may experience leaking because the o-ring adjusts to the shape of the old filter, which may be slightly different than the new filter
7. 7. The Omnipure H-011 O-Ring is the smaller o-ring in the Q-Series Head