X

Save with Auto-Ship

Get the product you need, exactly when you need it, delivered right to your door. No more searching for the right part number, we've got you covered. Plus, you'll save $$ on every order and shipping is on us. Learn more

Save Money

Free Shipping*

Choose Frequency

*Free Shipping available in the contiguous US

10 X 4.5 Carbon Block Replacement Filter by Tier1 (0.5 micron)

SKU
TIER1-CBC-10BB
Price $42.99
Availability: In Stock
Choose a quantity
  • 1 Filter $42.99  
  • 3 Filters Price $41.99 each
  • 6 Filters Price $40.99 each
  • Ships fast
  • Installs quickly and easily
  • Reduces impurities down to 0.5 micron
  • Fits most water filter housings requiring a 10 x 4.5 inch filter
See more product details
The 10 X 4.5 Carbon Block Replacement Filter by Tier1 is comparable to the Pentek CBC-BB Carbon Block Water Filter. Manufactured to reduce impurities down to 0.5 micron, this filter is built for performance. Designed for maximum flirtation, but priced for maximum value, Tier1 water filters provide great tasting water at a great looking price. Order the 10 X 4.5 Carbon Block Replacement Filter by Tier1 today!
Package Qty 1
Used In Brands 3M, Aqua-Pure, Culligan, Pentek, Tier1
Manufacturer's Id CBC-10BB
UPC 635510442691
Advertised Size (in) 10 x 4-1/2
Actual Size (in) 9.5 inches (length) x 4 1/2 inches (outside diameter)
Actual Size (cm) 24.13 x 11.43
Primary Filter Media Activated Carbon Block
Filter Life (gallons) 500
Filter Life (months) 6 months
Micron Rating (Nominal) 0.5
Operating Temperature (°F) 40 - 180
Operating Temperature (°C) 4.4 - 82.2
Flow Rate (gpm) 2
Flow Rate (lpm) 7.57
Warranty Guarantee Unconditional Product Guarantee for Life of the Product

Reduced Contaminants

The TIER1-CBC-10BB reduces the following contaminants:

  • Bad Taste and Odor
  • Chlorine Taste & Odor
  • Cysts
  • Sediment

The TIER1-CBC-10BB is comparable with the following part numbers

CBC10BB
CBC-10BB
155170-43
CBC-BB
PENTEK-CBC-BB

Instructions

  1. Turn off water supply. Press red pressure-relief button (if present)
  2. Unscrew housing. Remove large o-ring, wipe clean and set aside
  3. Discard used filter cartridge
  4. Wash housing with dish soap and warm water using a nonabrasive sponge or cloth. Rinse thoroughly
  5. Fill 1/3 with water. Add about 1 tablespoon of bleach and scrub to disinfect. Rinse thoroughly
  6. Lubricate o-ring with clean silicone grease. Change o-ring if any damage cuts or degradation are present. Insert o-ring in groove
  7. NOTE: This step is important to ensure a proper housing seal. Make certain the o-ring is seated level in the groove
  8. Insert new filter cartridge
  9. Screw housing onto the cap and hand-tighten. Do not over tighten. Make sure cap standpipe slips into cartridge
  10. Turn on water supply. Press pressure-relief button (if present). Check for leaks before leaving installation

Reset Instructions