10 X 2.5 Pleated Cellulose Replacement Filter by Tier1 (20 micron)

SKU
TIER1-S20-934
Price $6.99
Availability: In stock
Choose a quantity
  • 1 Filter $6.99  
  • 3 Filters Price $6.79 each
  • 6 Filters Price $6.59 each
  • Pleated Cellulose filter media
  • Not designed for well water filtration
  • Fits many common housings with a 10 inch by 2.5 inch size
  • Manufactured compatibility with the GE FXWPC and Pentek S1
See more product details
The Pentek S1 comparable by Tier1 is a 10 x 2.5 inch whole house water filter for drinking water applications that require reduction of dirt, sediment, sand, scale, silt, and rust. Pleated Cellulose filter media headlines this 20 micron replacement filter that will meet your filtering challenges head on. Order today!
Package Qty 1
Used In Brands Pentair, Pentek, Tier1
Manufacturer's Id S20-934
UPC 700355941033
Advertised Size (in) 10 x 2-1/2
Actual Size (in) 9 3/4 inches (length) x 2 1/2 inches (outside diameter)
Actual Size (cm) 24.77 x 6.096
Media Pleated Cellulose
Primary Filter Media Pleated Cellulose
Filter Life (months) 6 months
Micron Rating (Nominal) 20
Operating Temperature (°F) 40 - 145
Operating Temperature (°C) 4.4 - 79.4
Flow Rate (gpm) 12
Flow Rate (lpm) 37.854
Warranty Guarantee Unconditional Product Guarantee for Life of the Product

Reduced Contaminants

The TIER1-S20-934 reduces the following contaminants:

  • Dirt
  • Particles
  • Sand
  • Sediment
  • Silt

The TIER1-S20-934 is comparable with the following part numbers

PENTEK-S1
GE FXWPC

Instructions

  1. Turn off water supply. Press red pressure-relief button (if present).
  2. Unscrew housing. Remove large o-ring, wipe clean and set aside.
  3. Discard used filter cartridge. Wash housing with dish soap and warm water using a nonabrasive sponge or cloth. Rinse thoroughly. Fill 1/3 with water. Add about 1 tablespoon of bleach and scrub to disinfect. Rinse thoroughly.
  4. Lubricate o-ring with clean silicone grease. Change o-ring if any damage cuts or degradation are present. Insert o-ring in groove.
  5. Insert new filter cartridge.
  6. Screw housing onto the cap and hand-tighten. Do not over tighten. Make sure cap standpipe slips into cartridge.
  7. Turn on water supply. Press pressure-relief button (if present). Check for leaks before leaving installation.

Reset Instructions