Pentek UVS-110-1 120V UltraViolet Water Filtration System

SKU
PENTEK-UVS-110-1
Price $280.99
Availability: Discontinued
Choose a quantity
  • 1 Filter $280.99  
  • 3 Filters Price $272.59 each
  • 6 Filters Price $264.09 each
The Pentek UVS-110-1 system is constructed with a durable polypropylene housing, quartz sleeve to protect the lamp end, provides maximum UV transmittance, a UL-listed voltage regulated control module, mounting bracket and hardware. The UVS-110-1 system provides a germicidal dose of Ultraviolet light (16,000 microwatt-sec per square centimeter) at a wavelength of 254 nanometers which disrupts the microbes reproductive process. The Pentek UVS-110-1 system provides Ultraviolet water disinfection. The Pentek UVS-110-1 Ultraviolet light will protect drinking water sources from occasional intrusion of microbiological contamination. By using Ultraviolet light to control microbes, this Ultraviolet system is a positive alternative to environmentally harmful chemicals. The Pentek UVS-110-1 system is equipped with a CBU-10 Carbon Block Water Filter cartridge to protect against cryptosporidium and giardia cysts. What is included with the Pentek UVS-110-1 Ultraviolet System? The UVS-110-1 is a complete system ready for use. The Pentek UVS-110-1 includes the housing, UV control module with mounting bracket, CBU-10 carbon water filter, quartz sleeve, lamp, wrench, o-ring, and instructions.
Package Qty 1
Used In Brands Pentek
Manufacturer's Id UVS-110-1
UPC 799932596285
Actual Size (in) 15 1/2 inches (length) x 5 1/2 inches (width)
Actual Size (cm) 39.37 x 13.97
Materials of Construction O-Ring: Buna-N, Housing: Polypropylene, Cap: Polypropylene, UV Sleeve: Quartz
Filter Life (months) 12 months
Maximum Operating Pressure (psi) 65
Operating Temperature (°F) 40 - 100
Operating Temperature (°C) 4.4 - 37.8
Flow Rate (gpm) 1.00
Flow Rate (lpm) 3.79
Fitting Size (inches) 1/2 inch
Includes Filter Housing, UV Control Module with Mounting Bracket, CBU-10 Filter, Quartz Sleeve, Lamp, Wrench, O-ring, Instructions

Reduced Contaminants

The PENTEK-UVS-110-1 is comparable with the following part numbers

163003
UVS-110-1

User Guide

Instructions

  1. For installation on cold water lines. Do not install where system is exposed to direct sunlight. Allow a minimum of 12-inches clearance under the filter for changing the cartridge and above the system to allow the UV bulb to be changed
  2. Protect against freezing to prevent cracking of the system and water leakage
  3. Do not look directly at the UV lamp. This can cause retina/eye damage
  4. The UVS-110-1 system incorporates a carbon block filter cartridge that surrounds the quartz tube. This cartridge provides prefiltration that assures maximum transmittance of UV light and reduction of cysts such as Cryptosporidium and Giardia
  5. Turn off all electrical power to the system by unplugging or throwing the circuit
  6. Unscrew the UV control module from the mounting bracket (4 screws)
  7. Slide the old bulb out and unplug from the control module. NOTE: Hold the UV lamp only by the plastic covered ends of the bulb
  8. Carefully discard the old UV lamp
  9. Holding the new UV lamp only by the plastic covered ends of the bulb, plug the new UV lamp into the control module or power cord. Slide the new bulb into the cartridge housing and reattach UV control module or secure mounting bracket retainer
  10. Restore electrical power to unit and check for leaks

Reset Instructions