Rusco 3/4-200ST HT-F Hot Water Sediment Trapper Filter System

SKU
RUSCO-34-200STHT-F
Price $153.19
Availability: In stock
Choose a quantity
  • 1 Filter $153.19  
  • 3 Filters Price $148.59 each
  • 6 Filters Price $143.99 each
The Rusco hot water filter can operate up to 200 degrees F (93C) because of its industrial grade parts. The Rusco hot water filter systems come with female threads with a stainless steel reinforcing ring over the inlet and outlet. The Rusco filter system uses centrifugal separation technology to filter large sediment from water. The Rusco filters have a cover through which sediment is visible. The Rusco High Temperature filter has a flush outlet for one step purging. The Rusco Sediment Filter has a durable and reusable stainless steel filter screen. The Rusco Hot Water Filtration Systems have stainless steel reinforced pipe connections. The Rusco High Temperature Sediment Filter has a hand tightened cover that requires no tools to remove and clean.
Package Qty 1
UPC 659498021907
Actual Size (in) 14-3/8 inches (length) x 5 inches (width)
Media Polypropylene with Stainless Steel Mesh
Primary Filter Media Polypropylene
Flow Rate (gpm) 10
Flow Rate (lpm) 37.85
Fitting Size (inches) 3/4 inch

Contaminants

Reduces the following contaminants:

  • Coarse Sand
  • Extra Fine Sand
  • Fine Sand
  • Hard Scale
  • Sediment

Instructions

  1. Install the filter in a location that protects it from damage such as impact, freeze, excessive heat, chemical contact and water hammer
  2. Install the filter in the preferred vertical position with the purge outlet pointing down and also where it can be easily accessed for cleaning and maintenance
  3. Install the filter on the discharge side of the pump to allow the filter to be cleaned by purging through the flush valve
  4. Refer to arrows on the filter body for correct water flow direction. Adhere to all local and state codes, laws and regulations
  5. This system connects via female pipe threadsthreads (no glue is needed to connect this system, like other Rusco systems)
  6. The Rusco filter screens should be cleaned every few months. No tools are required for cleaning. The filter screen should be replaced every 6-12 months depending on your water usage and water quality
  7. The primary method of cleaning the Rusco filter is purging separated solids through the flush valve while the filter is under system pressure
  8. The purging process can be done manually with the flush valve or automated with our optional Automatic Flush Valve
  9. The filter element may need to be removed and cleaned. To remove the filter element, turn off the water supply, drain water pressure, unscrew the clear cover and remove the filter element
  10. Wash off collected sediment by spraying with water. Remove fine particles wedged in the screen with a soft brush. Apply silicone grease to o-rings if needed and reassemble. HAND TIGHTEN ONLY

Reset Instructions