Rusco 3/4-500-F Polyester Screened Spin-Down Filter System

The Rusco clear cover is made of high impact polymer resin for maximum strength and durability. The top of the Rusco system is made of PVC. The Rusco sediment filters use centrifugal separation technology to filter sediment from water. The Rusco filtration system has a polyester screen filter. The Rusco filter system's filter screen is cleanable and reusable. The Rusco systems have a clear cover that can easily be removed for cleaning. No tools are required to remove the cover. Sediment is visible through the clear cover indicating when the filter needs to be flushed. Rusco Sediment Filters have an open ball valve to easily flush sediment. When the Rusco filter is full of sediment, simply open the ball valve to flush the sediment. Rusco water filtration systems are made from molded non-corrosive materials.

• Made in the U.S.A.
• Genuine OEM Product

Reduces the following contaminants:

• Dirt
• Sand
• Sediment
• Silt

Used In Brands	Rusco
Manufacturer's Id	3/4-500-F
UPC	659498013414
Actual Size (in)	11 3/8 inches (length) x 7 1/4 inches (width)
Actual Size (cm)	28.90 x 18.41
Mesh Size	500
Media	Spin-Down Filter System
Micron Rating (Nominal)	30
Operating Pressure (psi)	0 - 150
Operating Temperature (°F)	40 - 100
Operating Temperature (°C)	4.4 - 37.8
Flow Rate (gpm)	25
Flow Rate (lpm)	75.708
Fitting Type	FPT
Fitting Size (inches)	3/4 inch
Additional Information	Service flow rate: 10 GPM

• Rusco 3/4-500-F Spin-Down Filter System Replacement Parts:
• Rusco .75C Spin-Down Replacement Filter Cover
• Rusco .75B Replacement Filter Head
• Rusco FS-3/4-500 Polyester Replacement Filter Screen
• Rusco .75OR Replacement O-Ring Kit
• Rusco SS1 Sun Shield is an optional accessory to block sunlight from coming through the cover.
• Rusco .5FV Replacement Manual Flush Valve
• The Rusco AFV Automatic Flush Valve is an optional accessory for automating the flushing of the Rusco filter system.

Instructions

1. 1. Install in a location that is protected from impact, freeze, excessive heat, chemical contact and water hammer.
2. 2. Install in the vertical position with the purge outlet pointing down.
3. 3. Install filter on discharge side of pump, allowing filter to be cleaned by purging through the flush valve.
4. 4. Refer to arrows on the filter body for correct water flow direction.