Rusco FS-1-1/2-200SS Spin-Down Steel Replacement Filter

Rusco sediment filters make solid particle removal simple and economical. The Rusco replacement filter screen can be cleaned several times before needing to be replaced. The Rusco filter screen is easy to clean. No tools required. This Rusco replacement filter element is made of stainless steel for heavy duty sediment filtration. The Rusco sediment screen elements are also available in polyester.

• Genuine OEM Product

Reduces the following contaminants:

• Coarse Sand
• Extra Fine Sand
• Fine Sand
• Hard Scale
• Sediment

• Rusco FS-1-12-200SS Stainless Steel Screen Element:
• Screen Mesh Size: 200
• Micron Rating: 74
• Contaminant Reduction: shale, shell, debris, pipe scale, and sand/grit (course, fine, and very fine)
• Inlet/Outlet Pipe Size dimension:1.5"

• Rusco FS-1-1/2-200SS Stainless Steel Screened Filter Element Replacements:
• Rusco 1.5C Spin-Down Replacement Filter Cover
• Rusco 1.5B Replacement Filter Head
• Rusco 1-1/2-200SS-F Spin-Down Filter System
• Rusco 1.5OR Replacement O-Ring Kit
• Rusco SS1.5 Sun Shield is an optional accessory to block sunlight from coming through the clear cover.
• Rusco .5FV Replacement Manual Flush Valve
• The Rusco AFV Automatic Flush Valve is an optional accessory for automating the flushing of the Rusco filter system.

Instructions

1. 1. After you have installed your Rusco system, you can simply turn the flush valve parallel with the system when you notice excessive buildup of sediment
2. 2. You should clean your filter screens every few months and replace them every 6-12 months depending on your water usage
3. 3. The primary method of cleaning the Rusco filter is purging separated solids through the flush valve while the filter is under system pressure (can be done manually with the flush valve or automated with the optional Automatic Flush Valve)
4. 4. The filter element may need to be removed and cleaned
5. 5. To remove the filter element turn off the water supply and drain water pressure
6. 6. Unscrew the clear cover and remove the filter element
7. 7. Wash off collected sediment by spraying with water
8. 8. Remove fine particles wedged in the screen with a soft brush
9. 9. Apply silicone grease to o-rings, if needed, and reassemble
10. 10. HAND TIGHTEN ONLY