Rusco FS-1-1/2-60STSS Sediment Trapper Steel Replacement Filter

SKU
RUSCO-FS-1-12-60STSS
Price $55.09
Availability: Special Order Item
Choose a quantity
  • 1 Filter $55.09  
  • 3 Filters Price $50.59 each
  • 6 Filters Price $49.09 each
Rusco sediment filters make solid particle removal simple and economical. The Rusco replacement filter screen can be cleaned several times before needing to be replaced. The Rusco filter screen is easy to clean. No tools required. This Rusco replacement filter element is made of stainless steel for heavy duty sediment filtration. The Rusco sediment screen elements are also available in polyester.
Package Qty 1
UPC 659498005617
Actual Size (in) 15 3/8 inches (length) x 5 1/4 inches (width)
Media Stainless Steel Screen
Primary Filter Media Stainless Steel
Fitting Size (inches) 1-1/2 inches

Reduced Contaminants

The RUSCO-FS-1-12-60STSS reduces the following contaminants:

  • Coarse Sand
  • Extra Fine Sand
  • Fine Sand
  • Hard Scale
  • Sediment

Instructions

  1. Install the filter in a location that protects it from damage such as impact, freeze, excessive heat, chemical contact and water hammer
  2. Install the filter in the preferred vertical position with the purge outlet pointing down and also where it can be easily accessed for cleaning and maintenance
  3. Install the filter on the discharge side of the pump to allow the filter to be cleaned by purging through the flush valve
  4. Refer to arrows on the filter body for correct water flow direction
  5. Adhere to all local and state codes, laws and regulations
  6. Use approved solvent cement for gluing PVC connections. Follow gluing instructions on glue container. REMOVE CLEAR CAP FROM THE PVC BODY PRIOR TO THE GLUING PROCESS. Any excess glue that comes in contact with the clear cover will damage it
  7. The Rusco filter screens should be cleaned every few months. No tools are required for cleaning. The filter screen should be replaced every 6-12 months depending on your water usage and water quality
  8. Clean Rusco filter by purging separated solids through the flush valve while the filter is under system pressure. The purging process can be done manually with the flush valve or automated with our optional Automatic Flush Valve
  9. The filter element may need to be removed and cleaned. To remove the filter element, turn off the water supply, drain water pressure, unscrew the clear cover and remove the filter element. Wash off collected sediment by spraying with water
  10. Remove fine particles wedged in the screen with a soft brush. Apply silicone grease to o-rings if needed and reassemble. HAND TIGHTEN ONLY

Reset Instructions