Rusco FS-1-250 Spin-Down Polyester Replacement Filter

Rusco sediment filters make solid particle removal simple and economical. The Rusco replacement screen elements can be cleaned several times before needing to be replaced. The Rusco filter screen is easy to clean. No tools required. This Rusco replacement filter element is made of polyester. The Rusco sediment screen elements are also available in stainless steel for heavy duty sediment filtration. Same as the Vu-Flow NT 30 SC 250.

• Advertised size includes ball valve attachment
• Genuine OEM Product

Reduces the following contaminants:

• Dirt
• Particulates
• Sand
• Sediment

Used In Brands	Rusco
Manufacturer's Id	FS-1-250
UPC	659498005181
Advertised Size (in)	11-3/8 x 5
Actual Size (in)	5 1/4 inches (height) x 1 1/4 (outside diameter)
Actual Size (cm)	13.335 x 3.175
Mesh Size	250
Media	Pleated Polyester w/ Screen
Primary Filter Media	Pleated Polyester
Micron Rating (Nominal)	61
Fitting Size (inches)	1 inch
Color / Finish	White
Includes	Spin-Down Polyester Replacement Filter

• Rusco FS-1-250 Polyester Screened Filter Element Replacements:
• Rusco 1C Spin-Down Replacement Filter Cover
• Rusco 1B Replacement Filter Head
• Rusco 1-250-F Spin-Down Filter System
• Rusco 1OR Replacement O-Ring Kit
• Rusco SS1 Sun Shield is an optional accessory to block sunlight from coming through the clear cover.
• Rusco .5FV Replacement Manual Flush Valve
• The Rusco AFV Automatic Flush Valve is an optional accessory for automating the flushing of the Rusco filter system.

Instructions

1. 1. After you have installed your Rusco system, you can simply turn the flush valve parallel with the system when you notice excessive buildup of sediment
2. 2. You should clean your filter screens every few months and replace them every 6-12 months depending on your water usage
3. 3. The primary method of cleaning the Rusco filter is purging separated solids through the flush valve while the filter is under system pressure (can be done manually with the flush valve or automated with the optional Automatic Flush Valve)
4. 4. The filter element may need to be removed and cleaned
5. 5. To remove the filter element turn off the water supply and drain water pressure
6. 6. Unscrew the clear cover and remove the filter element
7. 7. Wash off collected sediment by spraying with water
8. 8. Remove fine particles wedged in the screen with a soft brush
9. 9. Apply silicone grease to o-rings, if needed, and reassemble
10. 10. HAND TIGHTEN ONLY