Rusco FS-3/4-100STHT Hot Water Sediment Trapper Replacement Filter

SKU
RUSCO-FS-34-100STHT
Price $26.99
Availability: Out of stock
  • Advertised size includes ball valve attachment
See more product details
Rusco sediment filters make solid particle removal simple and economical. The Rusco hot water filter screens can be used up to a maximum temperature of 200 degrees Fahrenheit (93 degrees Celsius) at 40 PSI. The Rusco replacement filter screen can be cleaned several times before needing to be replaced. The Rusco filter screen is easy to clean. No tools required. This Rusco replacement filter element is made of stainless steel for heavy duty sediment filtration.
Package Qty 1
Used In Brands Rusco
Manufacturer's Id FS-34-100STHT
UPC 659498021570
Advertised Size (in) 14-3/8 x 5
Actual Size (in) 5 1/4 inches (length) x 1 1/4 inches (outside diameter)
Actual Size (cm) 13.335 x 3.175
Mesh Size 100
Media Stainless Steel Screen
Primary Filter Media Spindown
Micron Rating (Nominal) 152
Operating Pressure (psi) 0 - 150
Flow Rate (gpm) 25
Flow Rate (lpm) 94.6353
Fitting Size (inches) 3/4 inch
Warranty Guarantee 1 Year Warranty

Reduced Contaminants

The RUSCO-FS-34-100STHT reduces the following contaminants:

  • Dirt
  • Sand
  • Sediment
  • Silt

Instructions

  1. After you have installed your Rusco system, you can simply turn the flush valve parallel with the system when you notice excessive buildup of sediment
  2. You should clean your filter screens every few months and replace them every 6-12 months depending on your water usage
  3. The primary method of cleaning the Rusco filter is purging separated solids through the flush valve while the filter is under system pressure (can be done manually with the flush valve or automated with the optional Automatic Flush Valve)
  4. The filter element may need to be removed and cleaned
  5. To remove the filter element turn off the water supply and drain water pressure
  6. Unscrew the clear cover and remove the filter element
  7. Wash off collected sediment by spraying with water
  8. Remove fine particles wedged in the screen with a soft brush
  9. Apply silicone grease to o-rings, if needed, and reassemble
  10. HAND TIGHTEN ONLY

Reset Instructions