Rusco FS-3/4-60STHT Hot Water Sediment Trapper Replacement Filter

SKU
RUSCO-FS-34-60STHT
Price $31.99
Availability: Special Order Item
Choose a quantity
  • 1 Filter $31.99  
  • 6 Filters Price $31.19 each
Rusco sediment filters make solid particle removal simple and economical. The Rusco hot water filter screens can be used up to a maximum temperature of 200 degrees Fahrenheit (93 degrees Celsius) at 40 PSI. The Rusco replacement filter screen can be cleaned several times before needing to be replaced. The Rusco filter screen is easy to clean. No tools required. This Rusco replacement filter element is made of stainless steel for heavy duty sediment filtration.
Package Qty 1
Actual Size (in) 5 1/4 inches (length) x 1 1/4 inches (outside diameter)
Actual Size (cm) 13.335 x 3.175
Media Stainless Steel Screen
Primary Filter Media Spindown
Micron Rating (Nominal) 254
Fitting Size (inches) 3/4 inch

Reduced Contaminants

The RUSCO-FS-34-60STHT reduces the following contaminants:

  • Coarse Sand
  • Extra Fine Sand
  • Fine Sand
  • Hard Scale
  • Sediment

Instructions

  1. After you have installed your Rusco system, you can simply turn the flush valve parallel with the system when you notice excessive buildup of sediment
  2. You should clean your filter screens every few months and replace them every 6-12 months depending on your water usage
  3. The primary method of cleaning the Rusco filter is purging separated solids through the flush valve while the filter is under system pressure (can be done manually with the flush valve or automated with the optional Automatic Flush Valve)
  4. The filter element may need to be removed and cleaned
  5. To remove the filter element turn off the water supply and drain water pressure
  6. Unscrew the clear cover and remove the filter element
  7. Wash off collected sediment by spraying with water
  8. Remove fine particles wedged in the screen with a soft brush
  9. Apply silicone grease to o-rings, if needed, and reassemble
  10. HAND TIGHTEN ONLY

Reset Instructions