Rusco 1-1/4-100 HT-F Hot Water Spin-Down Filter System

The Rusco hot water filter can operate up to 200 degrees F (93C) because of its industrial grade parts. The Rusco hot water filter systems come with female threads with a stainless steel reinforcing ring over the inlet and outlet. The Rusco filter system uses centrifugal separation technology to filter large sediment from water. The Rusco filters have a cover through which sediment is visible. The Rusco High Temperature filter has a flush outlet for one step purging. The Rusco Sediment Filter has a durable and reusable stainless steel filter screen. The Rusco Hot Water Filtration Systems have stainless steel reinforced pipe connections. The Rusco High Temperature Sediment Filter has a hand tightened cover that requires no tools to remove and clean.

• Made in the U.S.A.
• Genuine OEM Product

Reduces the following contaminants:

• Coarse Sand
• Dirt
• Extra Fine Sand
• Fine Sand
• Sand
• Sediment

Used In Brands	Rusco
Manufacturer's Id	1-1/4-100HT-FÂ
UPC	659498017573
Actual Size (in)	15 3/8 inches (length) x 5 1/4 inches (width)
Actual Size (cm)	39.05 x 13.34
Mesh Size	100
Materials of Construction	Body Material: Polypropylene with 304 Stainless Steel Support Ring, Cover Material: Chemical and Heat Resistant HP Polymer, Screen Material: Polypropylene with 316 Stainless Steel Mesh, Flush Valve: CPVC, O-Rings: Buna-N
Micron Rating (Nominal)	152
Operating Pressure (psi)	0 - 150
Operating Temperature (°F)	40 - 200
Operating Temperature (°C)	4.4 - 93.3
Fitting Type	FPT
Fitting Size (inches)	1-1/4 inches

• Rusco 1-1/4-100HT-F Hot Water Filter System Replacement Parts:
• Rusco 1.25C-HT High Temperature Replacement Filter Cover
• Rusco 1.25B HT High Temp Replacement Filter Head
• Rusco FS-1-1/4-100HT Hot Water Replacement Filter Screen
• Rusco SS1.5 Sun Shield is an optional accessory to block sunlight from coming through the cover.
• Rusco .5FV HT Hot Water Replacement Manual Flush Valve
• The Rusco AFV Automatic Flush Valve is an optional accessory for automating the flushing of the Rusco filter system.

Instructions

1. 1. Install in a location that is protected from impact, freeze, excessive heat, chemical contact and water hammer.
2. 2. Install in the vertical position with the purge outlet pointing down.
3. 3. Install filter on discharge side of pump, allowing filter to be cleaned by purging through the flush valve.
4. 4. Refer to arrows on the filter body for correct water flow direction.