We use cookies to make your experience better.
Tier1 Pentek ECP50-20BB Comparable Pleated Sediment Water Filter
SKU
TIER1-ECP50-20BB
Price $23.99 List Price Price $33.99 Save 29%
Availability: In Stock
Choose a quantity
1 Filter $23.99 -
3 Filters Price $22.57 each -
6 Filters Price $21.59 each
- Great cost effective alternative
- Large dirt holding capacity
- Do not use on well water
- Pleated media great for sediment capture
The Pentek ECP50-20BB Comparable Pleated Sediment Water Filter by Tier1, is a cost effective filter specializing in the reduction of sediment, sand, and silt. the pleated material of this filter helps to ensure a greater dirt holding capacity. Due to the large size of this filter, (20x4.5 inches) greater filtration is enacted due to more surface area in which to work with. The Tier1-ECP50-20BB is not recommended for well water, as the cellulose within the filter may break down when in contact with bacteria. Larger contaminates will be filtered out with a micron rating of 50. Be sure to order yours today!
Package Qty | 1 |
---|---|
Used In Brands | Pentek, Tier1 |
Manufacturer's Id | ECP50-20BB |
UPC | 641945741889 |
Advertised Size (in) | 20 x 4-1/2 |
Filter Life (months) | 6 months |
Micron Rating (Nominal) | 50 |
Operating Temperature (°F) | 40 - 125 |
Operating Temperature (°C) | 4.4 - 51.7 |
Flow Rate (gpm) | 20 |
Flow Rate (lpm) | 75.708 |
Warranty Guarantee | Unconditional Guarantee for Life of the Product |
Additional Information | End Cap Color: Yellow |
Reduced Contaminants
The TIER1-ECP50-20BB reduces the following contaminants:
- Dirt
- Fine Sand
- Hard Scale
- Rust and Corrosion
- Sediment
The TIER1-ECP50-20BB is comparable with the following part numbers
4PAY5 | |
255496-43 |
Instructions
- Turn off water supply. Press red pressure-relief button (if present)
- Unscrew housing. Remove large o-ring, wipe clean and set aside
- Discard used filter cartridge
- Wash housing with dish soap and warm water using a nonabrasive sponge or cloth. Rinse thoroughly
- Fill 1/3 with water. Add about 1 tablespoon of bleach and scrub to disinfect. Rinse thoroughly
- Lubricate o-ring with clean silicone grease. Change o-ring if any damage cuts or degradation are present. Insert o-ring in groove
- NOTE: This step is important to ensure a proper housing seal. Make certain the o-ring is seated level in the groove
- Insert new filter cartridge
- Screw housing onto the cap and hand-tighten. Do not over tighten. Make sure cap standpipe slips into cartridge
- Turn on water supply. Press pressure-relief button (if present). Check for leaks before leaving installation