We use cookies to make your experience better.
Tier1 10 inch x 2.5 inch Pleated Polyester Sediment Water Filter Kit (30 Micron)
SKU
TIER1_FHR_10_25_PLEATED_KIT
Price $15.99 List Price Price $22.99 Save 30%
Availability: In Stock
- Ships fast!
- Includes filter, o-ring and lubricant packet
- Manufactured for performance, priced for value
- Pleated design ensures greater dirt holding capacity
The Tier1 10 inch x 2.5 inch pleated polyester sediment water filter kit includes everything you for filter change maintenance. The exclusive kit includes a 30 micron pleated polyester filter, replacement O-ring, and lubricant packet to make your next filter change a breeze. The experts at Tier1 have worked hard to ensure this kit contains the filter and component you need to finish the job. Water taste and quality is critical business, the pleated polyester sediment water filter kit captures dirt, sand and sediment down to 30 microns. The replacement kit installs quickly and easily, order today!
Package Qty | 3 |
---|---|
Used In Brands | Tier1 |
Manufacturer's Id | FHR-10-25-PLEATED |
UPC | 641945752250 |
Advertised Size (in) | 10 x 2-1/2 |
Actual Size (in) | 9 7/8 inches (length) x 2 1/2 inches (outside diameter) |
Actual Size (cm) | 25.0825 x 6.35 |
Primary Filter Media | Pleated Polyester |
Filter Life (months) | 6 months |
Micron Rating (Nominal) | 30 |
Operating Temperature (°F) | 40 - 125 |
Operating Temperature (°C) | 4.4 - 51.7 |
Flow Rate (gpm) | 10 |
Flow Rate (lpm) | 37.854 |
Color | White |
Warranty Guarantee | Unconditional Product Guarantee for Life of the Product |
Includes | SPC-25-1030 Hydronix Comparable Replacement Filter, O-ring, and Lubricant |
Primary Filter Media | Pleated Polyester |
Reduced Contaminants
The TIER1_FHR_10_25_PLEATED_KIT reduces the following contaminants:
- Dirt
- Particulates
- Sand
- Sediment
- Silt
Instructions
- Turn off water supply. Press red pressure-relief button (if present)
- Discard used filter cartridge
- Fill 1/3 with water. Add about 1 tablespoon of bleach and scrub to disinfect. Rinse thoroughly
- Insert new filter cartridge
- Lubricate o-ring with clean silicone grease. Change o-ring if any damage cuts or degradation are present. Insert o-ring in groove
- NOTE: This step is important to ensure a proper housing seal. Make certain the o-ring is seated level in the groove
- Screw housing onto the cap and hand-tighten. Do not over tighten. Make sure cap standpipe slips into cartridge
- Turn on water supply. Press pressure-relief button (if present). Check for leaks before leaving installation