Tier1 20 inch x 2.5 inch Pleated Polyester Sediment Water Filter Kit (5 Micron)

Price $13.99
Availability: In Stock

Price as configured $13.99

  • Ships fast!
  • Includes filter, o-ring and lubricant packet
  • Manufactured for performance, priced for value
  • Pleated design ensures greater dirt holding capacity
See more product details
The Tier1 20 inch x 2.5 inch pleated polyester sediment water filter kit includes everything you need for filter change maintenance. The exclusive kit includes a 5 micron pleated polyester filter, replacement O-ring, and lubricant packet to make your next filter change a breeze. The experts at Tier1 have worked hard to ensure this kit contains the filter and component you need to finish the job. Water taste and quality is critical business, the pleated polyester sediment water filter kit by Tier1 captures dirt, sand and sediment down to 5 microns. The filter replacement kit installs quickly and easily, order today!
Package Qty 3
Used In Brands Tier1
Manufacturer's Id FHR-20-25-PLEATED
UPC 641945752311
Advertised Size (in) 20 x 2-1/2
Actual Size (in) 20 inches (length) x 2 1/2 inches (outside diameter)
Actual Size (cm) 50.8 x 6.35
Primary Filter Media Pleated Polyester
Filter Life (months) 6 months
Micron Rating (Nominal) 5
Operating Temperature (°F) 40 - 125
Operating Temperature (°C) 4.4 - 51.7
Flow Rate (gpm) 20
Flow Rate (lpm) 75.708
Color White
Warranty Guarantee Unconditional Product Guarantee for Life of the Product
Includes SPC-25-2005 Hydronix Comparable Replacement Filter, replacement O-ring, and lubricant packet
Primary Filter Media Pleated Polyester

Reduced Contaminants

The TIER1_FHR_20_25_PLEATED_KIT reduces the following contaminants:

  • Dirt
  • Particulates
  • Sand
  • Sediment
  • Silt


  1. Turn off water supply. Press red pressure-relief button (if present)
  2. Discard used filter cartridge
  3. Fill 1/3 with water. Add about 1 tablespoon of bleach and scrub to disinfect. Rinse thoroughly
  4. Insert new filter cartridge
  5. Lubricate o-ring with clean silicone grease. Change o-ring if any damage cuts or degradation are present. Insert o-ring in groove
  6. NOTE: This step is important to ensure a proper housing seal. Make certain the o-ring is seated level in the groove
  7. Screw housing onto the cap and hand-tighten. Do not over tighten. Make sure cap standpipe slips into cartridge
  8. Turn on water supply. Press pressure-relief button (if present). Check for leaks before leaving installation

Reset Instructions