X

Save with Auto-Ship

Get the product you need, exactly when you need it, delivered right to your door. No more searching for the right part number, we've got you covered. Plus, you'll save $$ on every order and shipping is on us. Learn more

Save Money

Free Shipping*

Choose Frequency

*Free Shipping available in the contiguous US

Tier1 40 inch x 2.5 inch Whole House Sediment Water Filter (25 Micron)

SKU
TIER1-P25-40
Price $17.99
Availability: In Stock
Fits large 40 x 2.5 inch housings
  • Made from NSF 42 certified materials
  • Resistant to various fluids including acids, alkalies, and other liquids
  • Greater dirt holding capacity
  • Inhibits the growth of bacteria
See more product details
The Tier1 40 inch x 2.5 inch whole house sediment water filter (25 Micron) (TIER1-P25-40), captures medium to fine sediment. The spun wound media captures more dirt than string wound options. The large size of this filter, ensures greater surface area, and is perfect for commercial applications. In addition this filter is both bacteria and chemical resistant, able to withstand various types of fluids such as acids and alkalis. Order today!
Package Qty 1
Used In Brands Hydronix, Tier1
Manufacturer's Id P25-40
UPC 799932619878
Advertised Size (in) 40 x 2-1/2
Actual Size (in) 40 inches (length) x 2-1/2 inches (outside diameter)
Actual Size (cm) 101.6 x 6.35
Media Spun Wound Polypropylene
Primary Filter Media Polypropylene
Filter Life (months) 6 months
Micron Rating (Nominal) 25
Operating Temperature (°F) 40 - 145
Operating Temperature (°C) 4.4 - 62.8
Flow Rate (gpm) 20
Flow Rate (lpm) 75.7082
Warranty Guarantee Unconditional Product Guarantee for Life of the Product
Primary Filter Media Polypropylene

Reduced Contaminants

The TIER1-P25-40 reduces the following contaminants:

  • Dirt
  • Particles
  • Sediment

The TIER1-P25-40 is comparable with the following part numbers

SDC-25-4025
SDF-25-4025

Instructions

  1. Turn off water supply. Press red pressure-relief button (if present)
  2. Unscrew housing. Remove large o-ring, wipe clean and set aside
  3. Discard used filter cartridge
  4. Wash housing with dish soap and warm water using a nonabrasive sponge or cloth. Rinse thoroughly
  5. Fill 1/3 with water. Add about 1 tablespoon of bleach and scrub to disinfect. Rinse thoroughly
  6. Lubricate o-ring with clean silicone grease. Change o-ring if any damage cuts or degradation are present. Insert o-ring in groove
  7. NOTE: This step is important to ensure a proper housing seal. Make certain the o-ring is seated level in the groove
  8. Insert new filter cartridge
  9. Screw housing onto the cap and hand-tighten. Do not over tighten. Make sure cap standpipe slips into cartridge
  10. Turn on water supply. Press pressure-relief button (if present). Check for leaks before leaving installation

Reset Instructions