Tier1 40 inch x 2.5 inch Whole House Sediment Water Filter (50 Micron)

SKU
TIER1-P50-40
Price $14.99
Availability: In Stock
Fits housings sized at 40 x 2.5 inches
  • Resistant to acids, alkalies, and other liquids
  • Greater dirt holding capacity than most string wound filters
  • Inhibits the growth of bacteria
  • Excellent surface area for maximum filtration
See more product details
The Tier1 40 inch x 2.5 inch whole house sediment water filter (50 Micron), Tier1-P50-40, is a spun wound sediment water filter designed primarily for commercial applications. The 50 micron size of this filter captures medium to fine sediment. This filter is resistant to bacteria and chemicals, and is durable against a wide array of fluids such as acids and alkalis. The large surface area of this filter ensures lots of filtration power, and has a large dirt holding capacity, compared to many string wound filters. Order your Tier1 40 inch x 2.5 inch whole house sediment water filter today!
Package Qty 1
Used In Brands Hydronix, Tier1
Manufacturer's Id P50-40
UPC 799932625039
Advertised Size (in) 40 x 2-1/2
Actual Size (in) 40 inches (length) x 2-1/2 inches (outside diameter)
Actual Size (cm) 101.6 x 6.35
Media Spun Wound Polypropylene
Primary Filter Media Polypropylene
Filter Life (months) 6 months
Micron Rating (Nominal) 50
Operating Temperature (°F) 40 - 125
Operating Temperature (°C) 4.4 - 51.7
Color White
Warranty Guarantee Unconditional Product Guarantee for Life of the Product
Primary Filter Media Polypropylene

Reduced Contaminants

The TIER1-P50-40 reduces the following contaminants:

  • Dirt
  • Sand
  • Sediment
  • Silt

The TIER1-P50-40 is comparable with the following part numbers

HYDRONIX-SDC-25-4050
SDC-25-4050

Instructions

  1. Turn off water supply. Press red pressure-relief button (if present)
  2. Unscrew housing. Remove large o-ring, wipe clean and set aside
  3. Discard used filter cartridge
  4. Wash housing with dish soap and warm water using a nonabrasive sponge or cloth. Rinse thoroughly
  5. Fill 1/3 with water. Add about 1 tablespoon of bleach and scrub to disinfect. Rinse thoroughly
  6. Lubricate o-ring with clean silicone grease. Change o-ring if any damage cuts or degradation are present. Insert o-ring in groove
  7. NOTE: This step is important to ensure a proper housing seal. Make certain the o-ring is seated level in the groove
  8. Insert new filter cartridge
  9. Screw housing onto the cap and hand-tighten. Do not over tighten. Make sure cap standpipe slips into cartridge
  10. Turn on water supply. Press pressure-relief button (if present). Check for leaks before leaving installation

Reset Instructions