Tier1 30 inch x 2.5 inch Whole House Sediment Water Filter (75 Micron)

SKU
TIER1-P75-30
Price $16.99
Availability: In stock
Fits housings that accepts 30 x 2.5 inch cartridges
  • Ships fast
  • Rated for 75 microns
  • Will not nurture bacteria growth
  • Made of a spun wound material that is chemical resistant
See more product details
The Tier1 30 inch x 2.5 inch whole house sediment water filter (75 Micron) Tier1-P75-30 is a spun wound polypropylene filter which reduces sediment in your water. Recommended for commercial applications, the large surface area ensures maximum filtration. In addition the spun wound material can hold more dirt than string wound filters. Filters down to 75 microns, larger particles are effectively reduced. Durability is a high factor in the Tier1-P75-30, as it is resistant to chemicals and bacteria in your water, as well as fluids such as acids and alkalis. Order today!
Package Qty 1
Used In Brands Hydronix, Tier1
Manufacturer's Id P75-30
UPC 799932625046
Advertised Size (in) 30 x 2-1/2
Actual Size (in) 30 inches (length) x 2 1/2 inches (outside diameter)
Actual Size (cm) 76.2 x 6.35
Media Spun Wound Polypropylene
Primary Filter Media Polypropylene
Filter Life (months) 6 months
Micron Rating (Nominal) 75
Operating Temperature (°F) 40 - 125
Operating Temperature (°C) 4.4 - 51.7
Color White
Warranty Guarantee Unconditional Product Guarantee for Life of the Product
Primary Filter Media Polypropylene

Reduced Contaminants

The TIER1-P75-30 reduces the following contaminants:

  • Dirt
  • Sand
  • Sediment
  • Silt

The TIER1-P75-30 is comparable with the following part numbers

HYDRONIX-SDC-25-3075
SDC-25-3075

Instructions

  1. Turn off water supply. Press red pressure-relief button (if present)
  2. Unscrew housing. Remove large o-ring, wipe clean and set aside
  3. Discard used filter cartridge
  4. Wash housing with dish soap and warm water using a nonabrasive sponge or cloth. Rinse thoroughly
  5. Fill 1/3 with water. Add about 1 tablespoon of bleach and scrub to disinfect. Rinse thoroughly
  6. Lubricate o-ring with clean silicone grease. Change o-ring if any damage cuts or degradation are present. Insert o-ring in groove
  7. NOTE: This step is important to ensure a proper housing seal. Make certain the o-ring is seated level in the groove
  8. Insert new filter cartridge
  9. Screw housing onto the cap and hand-tighten. Do not over tighten. Make sure cap standpipe slips into cartridge
  10. Turn on water supply. Press pressure-relief button (if present). Check for leaks before leaving installation

Reset Instructions