X

Save with Auto-Ship

Get the product you need, exactly when you need it, delivered right to your door. No more searching for the right part number, we've got you covered. Plus, you'll save $$ on every order and shipping is on us. Learn more

Save Money

Free Shipping*

Choose Frequency

*Free Shipping available in the contiguous US

Tier1 40 inch x 2.5 inch Whole House Sediment Water Filter (75 Micron)

SKU
TIER1-P75-40
Price $14.99
Availability: In Stock
Fits standard housings compatible with 40 x 2.5 inch cartridges
  • Ideal for commercial applications
  • Cost effective filter which saves you money!
  • Resistant to bacteria as well as acids and alkalies
  • Holds more dirt, and sized at 40 x 2.5 inches, enables great filtration
See more product details
The Tier1 40 inch x 2.5 inch whole house sediment water filter (75 Micron) Tier1-P75-40 is a spun wound polypropylene sediment filter, that has a micron rating of 75. The large surface area of the filter makes it a perfect match for filtering commercial applications. You even have a greater dirt holding capacity compared to string wound filters. This product is resistant to bacteria and chemicals in the water. Fluids such as acids and alkalis are compatible with the Tier1-P75-40. Order this filter today!
Package Qty 1
Used In Brands Hydronix, Tier1
Manufacturer's Id P75-40
UPC 799932625053
Advertised Size (in) 40 x 2-1/2
Actual Size (in) 40 inches (length) x 2-1/2 inches (outside diameter)
Actual Size (cm) 101.6 x 6.35
Media Spun Wound Polypropylene
Primary Filter Media Polypropylene
Filter Life (months) 6 months
Micron Rating (Nominal) 75
Operating Temperature (°F) 40 - 145
Operating Temperature (°C) 4.4 - 62.8
Flow Rate (gpm) 20
Flow Rate (lpm) 75.7082
Warranty Guarantee Unconditional Product Guarantee for Life of the Product
Primary Filter Media Polypropylene

Reduced Contaminants

The TIER1-P75-40 reduces the following contaminants:

  • Dirt
  • Particles
  • Sediment

The TIER1-P75-40 is comparable with the following part numbers

SDC-25-4075

Instructions

  1. Turn off water supply. Press red pressure-relief button (if present)
  2. Unscrew housing. Remove large o-ring, wipe clean and set aside
  3. Discard used filter cartridge
  4. Wash housing with dish soap and warm water using a nonabrasive sponge or cloth. Rinse thoroughly
  5. Fill 1/3 with water. Add about 1 tablespoon of bleach and scrub to disinfect. Rinse thoroughly
  6. Lubricate o-ring with clean silicone grease. Change o-ring if any damage cuts or degradation are present. Insert o-ring in groove
  7. NOTE: This step is important to ensure a proper housing seal. Make certain the o-ring is seated level in the groove
  8. Insert new filter cartridge
  9. Screw housing onto the cap and hand-tighten. Do not over tighten. Make sure cap standpipe slips into cartridge
  10. Turn on water supply. Press pressure-relief button (if present). Check for leaks before leaving installation

Reset Instructions