We use cookies to make your experience better.
Tier1 10 inch x 2.5 inch Pleated Sediment Water Filter (1 Micron)
SKU
TIER1-SPC-25-1001
Price $12.99 List Price Price $18.99 Save 31%
Availability: Discontinued
Choose a quantity
1 Filter $12.99 -
3 Filters Price $12.22 each -
6 Filters Price $11.69 each
- Ships fast!
- Tier1 SPC-25-1001 SPC comparable Series Polyester Water Filters are made for high quality performance
- Cost effective replacement filter
- Woven pleated polyester sediment filter
› See more product details
Both bacteria and chemical resistant, the Tier1 10 inch x 2.5 inch pleated sediment water Filter (1 Micron) is perfect for reducing dirt, sand and silt out of your water supply. This filter features a pleated design that allows it to reduce more particles such as sediment and dirt in addition to other particles down to 1 micron in size. In addition this filter is ideal for use in a variety of applications, such as commercial and residential. You can even wash the pleats of this filter, at least once during it's life, for more use . Order today!
Package Qty | 1 |
---|---|
Used In Brands | Hydronix, Pentek, Tier1 |
Manufacturer's Id | SPC-25-1001 |
UPC | 641945742268 |
Advertised Size (in) | 10 x 2-1/2 |
Actual Size (in) | 9 7/8 inches (length) x 2 1/2 inches (outside diameter) |
Actual Size (cm) | 25.0825 x 6.35 |
Outside Diameter (inches) | 2.5 |
Media | Non-Woven Pleated Polyester |
Filter Life (months) | 6 months |
Micron Rating (Nominal) | 1 |
Operating Temperature (°F) | 40 - 125 |
Operating Temperature (°C) | 4.4 - 51.7 |
Flow Rate (gpm) | 4 |
Flow Rate (lpm) | 15.12 |
Color | White |
Materials of Construction | Core: Polypropylene, End Caps: Vinyl Plastisol |
Warranty Guarantee | Unconditional Guarantee for Life of the Product |
Reduced Contaminants
The TIER1-SPC-25-1001 reduces the following contaminants:
- Dirt
- Particulates
- Sand
- Sediment
- Silt
The TIER1-SPC-25-1001 is comparable with the following part numbers
HYDRONIX-SPC-25-1001 |
SPC-25-1001 |
SDF-25-1001 |
255481-43 |
FM-1-975 |
Instructions
- Turn off water supply. Press red pressure-relief button (if present)
- Unscrew housing. Remove large o-ring, wipe clean and set aside
- Discard used filter cartridge
- Wash housing with dish soap and warm water using a nonabrasive sponge or cloth. Rinse thoroughly
- Fill 1/3 with water. Add about 1 tablespoon of bleach and scrub to disinfect. Rinse thoroughly
- Lubricate o-ring with clean silicone grease. Change o-ring if any damage cuts or degradation are present. Insert o-ring in groove
- NOTE: This step is important to ensure a proper housing seal. Make certain the o-ring is seated level in the groove
- Insert new filter cartridge
- Screw housing onto the cap and hand-tighten. Do not over tighten. Make sure cap standpipe slips into cartridge
- Turn on water supply. Press pressure-relief button (if present). Check for leaks before leaving installation