We use cookies to make your experience better. To comply with the new e-Privacy directive, we need to ask for your consent to set the cookies. Learn more.
Tier1 10 inch x 2.5 inch Pleated Sediment Water Filter (30 Micron)
SKU
TIER1-SPC-25-1030
Price $7.57 List Price Price $10.99 Save 31%
Availability: In Stock
Fits standard 10 x 2.5 inch water filter housings
Choose a quantity
1 filter $7.57 3 filters $6.91 each 6 filters $6.24 each
- Ships fast
- Holds more dirt than other filters
- Washable and reusable filter
- Can be used in a variety of applications such as commercial, residential, and industrial
› See more product details
- Ships fast
- Holds more dirt than other filters
- Washable and reusable filter
- Can be used in a variety of applications such as commercial, residential, and industrial
The Tier1 10 inch x 2.5 inch pleated sediment water filter (30 Micron) offers a pleated design that captures more dirt, and particles keeping your water clean and drinkable. Designed for applications such as residential, commercial and industrial environments this filter is resistant to bacteria and chemicals while also reducing different kinds of sediment. You can even wash and re-use this filter for better use. Be sure to order today!
Reduced Contaminants
The TIER1-SPC-25-1030 reduces the following contaminants:
- Dirt
- Particulates
- Sand
- Sediment
- Silt
The TIER1-SPC-25-1030 is comparable with the following part numbers
PENTEK-R30 |
Instructions
- Turn off water supply. Press red pressure-relief button (if present)
- Unscrew housing. Remove large o-ring, wipe clean and set aside
- Discard used filter cartridge
- Wash housing with dish soap and warm water using a nonabrasive sponge or cloth. Rinse thoroughly
- Fill 1/3 with water. Add about 1 tablespoon of bleach and scrub to disinfect. Rinse thoroughly
- Lubricate o-ring with clean silicone grease. Change o-ring if any damage cuts or degradation are present. Insert o-ring in groove
- NOTE: This step is important to ensure a proper housing seal. Make certain the o-ring is seated level in the groove
- Insert new filter cartridge
- Screw housing onto the cap and hand-tighten. Do not over tighten. Make sure cap standpipe slips into cartridge
- Turn on water supply. Press pressure-relief button (if present). Check for leaks before leaving installation