X

Save with Auto-Ship

Get the product you need, exactly when you need it, delivered right to your door. No more searching for the right part number, we've got you covered. Plus, you'll save $$ on every order and shipping is on us. Learn more

Save Money

Free Shipping*

Choose Frequency

*Free Shipping available in the contiguous US

10 X 2.875 Carbon Block Replacement Filter by Tier1 (20 micron)

SKU
TIER1-GAC-10
Price $18.99
Availability: In Stock
Choose a quantity
  • 1 Filter $18.99  
  • 3 Filters Price $17.87 each
  • 6 Filters Price $17.09 each
  • Easy to use
  • Residential application
  • Reduces bad chlorine and bad taste
See more product details
The Tier1 GAC-10 carbon water filter 20 micron granular activated carbon filter measuring 10-inch x 2.875-inch. Tier1 water filters are built for performance and priced for value. Following a quick and easy installation, this filter begins reducing impurities including chlorine taste, odor, and sediment. Order the 10 X 2.875 Carbon Block Replacement Filter by Tier1 (20 micron) today!
Package Qty 1
Used In Brands Tier1
Manufacturer's Id GAC-10
UPC 799932613869
Advertised Size (in) 10 x 2-1/2
Actual Size (in) 9 3/4 inches (length) x 2 7/8 inches (outside diameter)
Actual Size (cm) 24.77 x 7.3025
Media Granular Activated Carbon
Post Filter Media Spun Polypropylene
Materials of Construction End Caps: Polystyrene, Outer Casing: Polystyrene, Expansion Pad: Polypropylene, Gaskets: Buna-N (top) and Santoprene (bottom)
Filter Life (gallons) 5,000
Filter Life (liters) 18,927.05
Filter Life (months) 6 months
Micron Rating (Nominal) 20
Operating Temperature (°F) 40 - 125
Operating Temperature (°C) 4.4 - 51.7
Flow Rate (gpm) 1.00
Flow Rate (lpm) 3.79
Warranty Guarantee Unconditional Product Guarantee for Life of the Product

Reduced Contaminants

The TIER1-GAC-10 reduces the following contaminants:

  • Bad Taste and Odor
  • Chlorine Taste & Odor
  • Sediment

The TIER1-GAC-10 is comparable with the following part numbers

GAC-10
PENTEK-GAC-10

Instructions

  1. Turn off water supply. Press red pressure-relief button (if present)
  2. Unscrew housing. Remove large o-ring, wipe clean and set aside
  3. Discard used filter cartridge
  4. Wash housing with dish soap and warm water using a nonabrasive sponge or cloth. Rinse thoroughly
  5. Fill 1/3 with water. Add about 1 tablespoon of bleach and scrub to disinfect. Rinse thoroughly
  6. Lubricate o-ring with clean silicone grease. Change o-ring if any damage cuts or degradation are present. Insert o-ring in groove
  7. NOTE: This step is important to ensure a proper housing seal. Make certain the o-ring is seated level in the groove
  8. Insert new filter cartridge
  9. Screw housing onto the cap and hand-tighten. Do not over tighten. Make sure cap standpipe slips into cartridge
  10. Turn on water supply. Press pressure-relief button (if present). Check for leaks before leaving installation

Reset Instructions