Whirlpool 4396395 and Maytag UKF8001 EveryDrop EDR4RXD1 (Filter 4) Ice and Water Refrigerator Filter

Installation Guide

whirlpool-everydrop-series-installation-guide.pdf

Instructions

Note: Filter must be pushed firmly into receiver and turned until filter is locked in place. If filter is not locked correctly, water will not flow.
DO NOT use any tools to install this filter
Unlatch the plastic filter cover, and let it swing down (so you can see the filter)
Pull the filter straight out and discard (don't worry, the water will shut off automatically)
Push the new filter into the fridge until it stops, twist the filter a quarter-turn clockwise
Swing the plastic filter cover up until it snaps closed
Reset your change filter light (if your fridge has one)
Flush filter with 3-4 gallons of with water until water runs clear. Some noise is not uncommon as air is purged from the system.
If filter sits for several days without use, flush a quart of water through the filter to remove stale water from refrigerator water line

Reset Instructions

Press and hold the dispenser LOCK and AUTO-LIGHT (or WATER on some fridges) buttons on the dispenser at the same time for 4 seconds or until the filter status indicator begins to flash, then release the buttons