Tier1 GE MWF SmartWater Refrigerator Water Filter Replacement

The GE MWF SmartWater Refrigerator Water Filter Replacement comparable by Tier1, featuring a new design, installs quickly and easily, requiring no tools. The RWF1060 provides up to six months of great tasting, cleaner and fresher tasting drinking water. Manufactured to reduce contaminants ranging from chlorine to sediment. Start serving excellent drinking water, order the RWF1060 today!

Installation Guide

• Reduces many common water contaminants
• Lasts for up to six months, or 300 gallons, depending on use
• A cost effective alternative to expensive brand name refrigerator water filters

Used In Brands	GE, Hotpoint, Tier1
Manufacturer's Id	RWF1060
UPC	635510441922
Actual Size (in)	4 3/4 inches (length) x 3 1/4 inches (outside diameter)
Actual Size (cm)	12.065 x 8.255
Media	Coconut Carbon
Primary Filter Media	Activated Carbon Block
Filter Life (gallons)	1,500
Filter Life (months)	6 months
Micron Rating (Nominal)	0.5
Operating Pressure (psi)	30 - 120
Operating Temperature (°F)	33 - 100
Operating Temperature (°C)	0.6 - 37.8
Flow Rate (gpm)	1
Flow Rate (lpm)	3.8
Certifications	Filter cartridge has been Tested and Certified by NSF International against NSF/ANSI 42 for materials and structural integrity requirements
Warranty Guarantee	Unconditional Product Guarantee for Life of the Product
Additional Information	A low-cost alternative filter
Primary Filter Media	Activated Carbon Block

Instructions

1. 1. Note: Filter must be pushed firmly into receiver and turned until filter is locked in place. If filter is not locked correctly, water will not flow.
2. 2. DO NOT use any tools to install this filter
3. 3. Twist the old filter a quarter-turn counterclockwise
4. 4. Pull the filter straight down and discard (don't worry, the water will shut off automatically)
5. 5. Fill the new filter with water (you can use the cold water faucet on your kitchen sink)
6. 6. Push the new filter up into the fridge until it stops
7. 7. Twist the filter a half-turn clockwise
8. 8. Reset your change filter light (if your fridge has one)
9. 9. Flush filter with 3-4 gallons of with water until water runs clear. Some noise is not uncommon as air is purged from the system.

Resetting Your Filter Change Indicator