We use cookies to make your experience better.
20 X 4.5 Spun Wound Polypropylene Replacement Filter by Tier1 (1 micron)
SKU
TIER1-DGD1-20BB
Price $27.99 List Price Price $39.99 Save 30%
Availability: In Stock
Fits most stand housings built for 20-inch x 4.5 inch filter cartridges
Choose a quantity
1 filter $27.99 3 filters $26.34 each 6 filters $25.19 each
- Lasts for up to 3 months, depending on use and water quality
- Captures contaminants down to 1 micron
- Easy installation and filter exchanges within minutes
- Provides fresh, cleaner tasting water throughout your home
› See more product details
- Lasts for up to 3 months, depending on use and water quality
- Captures contaminants down to 1 micron
- Easy installation and filter exchanges within minutes
- Provides fresh, cleaner tasting water throughout your home
The Pentek DGD-2501-20 comparable whole house water filter by Tier1 is a bonded polypropylene filter ideal for 20 x 4.5 inch filter housings. The DGD1-20BB by Tier1 goes to work immediately, to help ensure you serve only the greatest tasting water of the highest quality to your family. From chlorine to sediment, the DGD1-20BB reduces common water contaminants for up to three months. Order today!
Polypropylene media inhibits bacterial growth making it an ideal option for both municipal and well water applications. These filters are effective at capturing contaminants such as sand, sediment, silt, and more. Unlike carbon filter cartridges you wont have to worry about small carbon fines potentially spilling into your water, while still enjoying the benefits of filtered water throughout your home. Polypropylene filters are great for whole house water filtration and can be
Reduced Contaminants
The TIER1-DGD1-20BB reduces the following contaminants:
- Coarse Sand
- Dirt
- Hard Scale
- Limescale
- Oxidized Iron
- Particles
- Sand
- Sediment
- Silt
The TIER1-DGD1-20BB is comparable with the following part numbers
DGD-2501-20 | 155360-43 |
DGD-2501-20 | FPMB-BB1-20 |
P1-20BB | Pentek DGD-2501-20 |
SDC-45-2001 | SDF-45-2001 |
TIER1-DGD1-20BB | TIER1-P1-20BB |
The TIER1-DGD1-20BB fits the following model numbers
W20FFPH1CBPR |
CFS22 |
Instructions
- Turn off water supply. Press red pressure-relief button (if present)
- Unscrew housing. Remove large o-ring, wipe clean and set aside
- Discard used filter cartridge. Wash housing with dish soap and warm water using a nonabrasive sponge or cloth. Rinse thoroughly.
- Fill 1/3 with water. Add about 1 tablespoon of bleach and scrub to disinfect. Rinse thoroughly.
- Lubricate o-ring with clean silicone grease. Change o-ring if any damage cuts or degradation are present. Insert o-ring in groove.
- NOTE: This step is important to ensure a proper housing seal. Make certain the o-ring is seated level in the groove.
- Insert new filter cartridge.
- Screw housing onto the cap and hand-tighten. Do not over tighten. Make sure cap standpipe slips into cartridge.
- Turn on water supply. Press pressure-relief button (if present). Check for leaks before leaving installation.