X

Save with Auto-Ship

Get the product you need, exactly when you need it, delivered right to your door. No more searching for the right part number, we've got you covered. Plus, you'll save $$ on every order and shipping is on us. Learn more

Save Money

Free Shipping*

Choose Frequency

*Free Shipping available in the contiguous US

Stainless Steel Flex Connector 1 Inch PTC X 1 Inch FIP (18-Inch)

SKU
PTC1JG-1N-18
Price $31.99 List Price Price $45.99 Save 30%
Availability: In Stock
  • Installs easily between systems and water line
  • Kink and crimp free to maintain optimal flow
  • Stainless steel construction that will not corrode or rust
› See more product details
  • Installs easily between systems and water line
  • Kink and crimp free to maintain optimal flow
  • Stainless steel construction that will not corrode or rust
Stainless Steel Flex Connector 1 Inch PTC X 1 Inch FIP (18-Inch). This whole house system component makes it easy to configure your water system. Push-to-connect fittings install easily and the flexible pipe design allows for minimal hassle with system spacing. Get your stainless steel flexible connector today!
Package Qty1
Used In BrandsCulligan
Actual Size (in)18 inches (Length) x 1 inch (Outside Diameter)
Inside Diameter (inches)1
Outside Diameter (inches)1
Materials of Construction304 Series Stainless Steel, Chrome plated brass nuts, Nylon
Maximum Operating Pressure (psi)200
Maximum Temperature (°F)250
Fitting TypeFIP, Quick Connect
Fitting Size (inches)1 inch
ColorStainless Steel Finish
CertificationsNSF/ANSI Standard 61

Reduced Contaminants

Instructions

  1. For use with WATER in accessible locations ONLY.
  2. Cut tube or pipe square; remove all burrs and sharp edges as these can damage the internal o-ring.
  3. Push fitting onto the pipe up to the tube stop.
  4. Pull on the fitting to check that it is secure.
  5. Check that the rubber washer is installed in the FIP nut of the connector. Bend connector slowly into approximate shape to join water supply to the inlet nipple of the water heater or other appliance and secure snugly. (Caution: do not over-tighten FIP nut or bend tube excessively). Repeat this process for the outlet side of the heater or appliance.
  6. Turn on the water supply and check connections for leaks.
  7. To disconnect, ensure that the system is depressurized, and push the white plastic collet square against the fitting. With two fingers pull back on the collet to remove.