X

Save with Auto-Ship

Get the product you need, exactly when you need it, delivered right to your door. No more searching for the right part number, we've got you covered. Plus, you'll save $$ on every order and shipping is on us. Learn more

Save Money

Free Shipping*

Choose Frequency

*Free Shipping available in the contiguous US

10 x 2.5 Inch Universal Carbon Block Under Sink Filter (0.5 Micron)

SKU
TIER1-US-D30
Price $16.99 List Price Price $23.99 Save 29%
Availability: In Stock
Choose a quantity
  • 1Filter$16.99 
  • 3Filters Price $15.99 each
  • 6Filters Price $15.29 each
  • Ships fast!
  • Reduces particles down to 0.5 microns in size
  • Both cost effective and great quality
See more product details
The Omnifilter CB3 Comparable Carbon Block Whole House Water Filter by Tier1, can reduce contaminates as small as 0.5 microns. If you have issues with chlorine taste and odor as well as sediment the TIER1-US-D30 is the perfect cost effective replacement. It takes just a moment to install, simply place in your housing and tighten the cap and your good to go. Be sure to order your carbon block filter today!
Package Qty1
Used In BrandsCulligan, GE, Pentek, ReplacementBrand, Tier1
Manufacturer's IdUS-D30
UPC641945742251
Advertised Size (in)10 x 2-1/2
Actual Size (in)9 3/4 inches (length) x 2-5/8 inches (diameter)
MediaRadial Flow Activated Carbon Block
Filter Life (gallons)600
Filter Life (liters)2,271.25
Filter Life (months)6 months
Micron Rating (Nominal)0.5
Flow Rate (gpm)1
Warranty GuaranteeUnconditional Guarantee for Life of the Product

Reduced Contaminants

The TIER1-US-D30 reduces the following contaminants:

  • Chlorine Taste & Odor
  • Sand
  • Sediment
  • Silt
  • Soil

The TIER1-US-D30 is comparable with the following part numbers

CB3 FXULC
FXUVC RB-D30
CBC-10 TIER1-US-D30
WHKF-DB2

The TIER1-US-D30 fits the following model numbers

HF-350
HF-150A
158642
158643

Instructions

  1. Turn off water supply. Press red pressure-relief button (if present)
  2. Unscrew housing. Remove large o-ring, wipe clean and set aside
  3. Discard used filter cartridge. Wash housing with dish soap and warm water using a nonabrasive sponge or cloth. Rinse thoroughly
  4. Fill 1/3 with water. Add about 1 tablespoon of bleach and scrub to disinfect. Rinse thoroughly
  5. Lubricate o-ring with clean silicone grease. Change o-ring if any damage cuts or degradation are present. Insert o-ring in groove
  6. NOTE: This step is important to ensure a proper housing seal. Make certain the o-ring is seated level in the groove
  7. Insert new filter cartridge
  8. Screw housing onto the cap and hand-tighten. Do not over tighten. Make sure cap standpipe slips into cartridge
  9. Turn on water supply. Press pressure-relief button (if present). Check for leaks before leaving installation

Reset Instructions